American Megatrends MegaRAC MG9070 Datasheet

MegaRAC
®
sAs/sAtA Enclosure Management Controller
HigHligHts
> supports up to 4 sAs/sAtA drives
>
Drive Activity, Rebuild & Fail lEDs
> supports Ready lED signal from
Drive
> Manages drive presence
>
global activity & global Fail indica-
tion
>
sgPiO protocol support to interface
to sAs/sAtA HBA
>
Enclosure Management Protocol
support for Promise HBA
>
Number of supported drives can
easily be increased by a factor of
4 by adding similar chips in case of
sgPiO interface
>
support for maximum of 8 drives in
case of Promise protocol
>
two sMBus ports and one sgPiO
port
MG9070
AMI's MG9070 enclosure management controller can be utilized with both
SATA and SAS backplanes for applications from entry-level to mission-critical, while
providing a cost effective solution that does not require an expander. The chip imple-
ments Enclosure Management Protocol for supporting Promise SATA HBA as well
as SGPIO per SFF 8485 specification, managing LEDs for up to four drives.
AMI, who gained high reputation in the storage industry with RAIDs, works
with all the major HBA vendors to ensure compatibility.
MegaRAC MG9070 chip manages
hot-swap SAS/SATA-II backplanes with
enclosure management, ideal for cost-sen-
sitive and performance-oriented system
designs. The device is compatible with
adapters supporting Enclosure Manage-
ment Protocol for Promise SATA HBA
or SAS adapters with SGPIO interface.
Each MG9070 has one SGPIO port that
can communicate enclosure management
information to the SAS host bus adapter,
support LED management and detect
drive presence for up to four drives.
Serial Attached SCSI (SAS) and Seri-
al ATA are the latest storage interconnect
standards, introducing higher speeds,
more robust data integrity, smaller de-
signs and wider standardization. The SAS
interface is compatible with lower-cost-
Backplane_ID
RESET#
MATED1
MATED2
MATED3
MATED4
per-gigabyte SATA drives, giving system
builders the flexibility to integrate either
SAS or SATA devices while slashing the
costs associated with supporting two
separate interfaces. As the next genera-
tion of SCSI, SAS bridges the parallel
technology gap in performance, scal-
ability and affordability.
The SAS interface is designed to be
compatible with the Serial ATA (SATA)
interface at physical layer level. This al-
lows SAS or SATA drives to be plugged
into a SAS backplane, which reduces de-
sign and inventory costs for backplane
manufacturers.
A backplane required to support only
four drives can have just one MG9070.
By adding more devices, the backplane
can manage 8, 16 drives or more.
SGPIO Interface I2C to
(SAS) Promise HBA
Drive
Presence
CPU Memory
XTAL1
Drive
Drive
Activity
Fail
XTAL2
LEDs
LEDs
© 2008 American Megatrends Inc. - Specifications subject to change without notice
Data sheet
4 30 2008
VCC
I2C
GND
Global ACT
GLOBAL_FAIL
& FAIL
GLOBAL_ACT
LOGIC
MB_ACT_IN#
MB ACT
LOGIC
MB ACT
Ready LED From
Drives