Advertisement
Quick Links
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
External Grounding Wire Adapter Cable
(Part # CABLE-HWS-G)
Use the External Grounding
Wire Adapter Cable to
electrically ground the HOBO
Micro Station logger. The
grounding wire is required if
you will be using a wind speed or wind speed and direction sensor with the logger or if the logger will be
placed in an exposed location on a tripod or tower.
Tools required
•
Small coin or slotted screwdriver
•
Phillips-head screwdriver
•
Crescent wrench
Installation
1. Use a slotted screwdriver or small coin to unscrew the external connection access port cover.
2. Insert the cable through the external connection access port. Screw in the fitting to seal the hole.
Hand-tighten the fitting and then tighten an additional ½ to ¾ turn with a crescent wrench.
© 2003 Onset Computer Corporation.
Part #: MAN-CAB-HWSG
Doc #: 7788-A
®
External connection
access port cover
Advertisement
Related Manuals for Onset Computer Corporation CABLE-HWS-G
Summary of Contents for Onset Computer Corporation CABLE-HWS-G
- Page 1 2. Insert the cable through the external connection access port. Screw in the fitting to seal the hole. Hand-tighten the fitting and then tighten an additional ½ to ¾ turn with a crescent wrench. © 2003 Onset Computer Corporation. Part #: MAN-CAB-HWSG...
- Page 2 Refer to the HOBO Micro Station User’s Guide for additional Micro Station setup information. For support with this product, contact the place of purchase: Onset Computer Corporation at 1-800-LOGGERS (1-800-564-4377) or an Authorized Onset Dealer. See also onsetcomp.com or hobohelp.com.
Need help?
Do you have a question about the CABLE-HWS-G and is the answer not in the manual?
Questions and answers