Auto-Switch Function-Usb Keyboard/Mouse Users, Please Read; Auto-Scan Function - Cables to Go Port Authority2 User Manual

* Auto- - - - Switch * Auto Switch Function:
* Auto * Auto Switch Switch
When Auto-Switch mode is ON:
When you enable the AutoSwitch mode the KVM will switch the HUB when
you switch the host. This means host and HUB will switch together by hotkey,
OSD, or push button. The USB devices always follow the host. This is the
required mode for a USB keyboard or mouse to work with all connected
computers.
There are two ways to turn the HUB Auto-Switch mode ON :
A). By hot key via PS/2 keyboard; [Scroll+Scroll][H] : please reference the
hotkey table in page 11.
B). Press and hold any of the PC port selector buttons continually for 2 seconds
when the Auto-Switch mode is OFF. The Auto-Switch LED will turn ON.
When Auto-Switch mode is OFF:
You must switch the hub to the new target host by hotkey.
There are two ways to turn the HUB Auto-Switch mode OFF:
A). By hot key via PS/2 keyboard; [Scroll+Scroll][H] : please reference the
hotkey table in page 11.
B). Press any host push button continually for 2 seconds when the Auto-Switch
mode in ON. The AutoSwitch LED will turn OFF.
* Auto- - - - Scan * Auto * Auto * Auto Scan Scan Function: Scan
When you press the Auto-Scan button, the KVM Switch cycles through all the
ports and displays them on the monitor. Each port is displayed for 5,10,15,20
seconds before switching to the next. You can press the normal numeric key
1,2,3,4 to adjust the interval time (Please reference the hotkey table in page 11).
If you press the Auto-Scan button again, the monitor screen will jump back to the
port that it was started.
Note:
The mouse and keyboard have no effect while in this mode. This is necessary to
prevent errors such as erratic movement and wrong characters to display when
using the mouse or keyboard accidentally.
Port Authority2 4-Port USB and PS2 KVM Switch
Function:
Function: Function:
Function: Function: Function:
12