Advertisement
Quick Links
User's Guide
CellSet MC/SP4
Kennedy Technology Group, Inc.
614 Ridgeway, Rose Hill, Kansas 67133 USA
voice 316.776.1111
fax 316.776.9035
email:kennedy@cellset.com
www.cellset.com
Thank you for purchasing our product!
We hope that your new CellSet gives you many hours of clear and comfortable operation.
This product was designed to connect to a variety of intercoms and cell phones. It must be used in
conjunction with a KTG Intercom Harness: and a KTG Cell Phone Harness (each sold and packaged
separately).
Connect CellSet Jack J1 to the Intercom Harness you purchased.
Next connect CellSet's plug P1 to the Cell Phone Harness you purchased.
Then connect CellSet plug P2 to the power harness (part # 85623) included with this assembly.
Switch S1 (under cover)
P2
J1 P1
Advertisement
Summary of Contents for Kennedy Technology Group CellSet MC/SP4
- Page 1 User’s Guide CellSet MC/SP4 Kennedy Technology Group, Inc. 614 Ridgeway, Rose Hill, Kansas 67133 USA voice 316.776.1111 fax 316.776.9035 email:kennedy@cellset.com www.cellset.com Thank you for purchasing our product! We hope that your new CellSet gives you many hours of clear and comfortable operation.
- Page 2 Remove the four screws from the top of the CellSet and remove the top cover. Locate the small red and black slide switch labeled “S1” (see figure for approximate location). Refer to the tag attached to the Cell Phone Harness you purchased. This tag indicates the proper position for this switch.