Cooper Lighting ClearCurve Wall Invue Installation Instructions Manual page 3

Switched Emergency Hot
Emergency Neutral
Normal Ground
Unswitched Emergency Hot
Dimming -
Dimming +
Normal Hot
Normal Neutral
Figure 4C. Integral Transfer Switch (ITS or GTDU)
5. Lift the fixture and remove balled end cable from slot
in wedge plate. Feed the power wires and connections
into the junction box. Set the fixture on the wedge
plate. Ensure that the luminaire supply leads are not
pinched between the wedge plate and the housing.
6. Tighten the two set screws on the fixture to 20 in-lbs.
(Figure 5).
Wedge Plate
Figure 5.
WALL MOUNT (AC POWER THROUGH THE
SIDE OF THE FIXTURE (C1 OR C2 OPTION))
Tools Required:
#2 Phillips head screwdriver, 1/8" Hex
allen wrench, torque wrench, tool for screw mounting
hardware (by other), tools for outdoor rated conduit (by
other).
1. When mounting the fixture with AC power through
the side of the fixture, the fixture mounting process
is different. Fixtures ordered with the C1 or C2 option
will not have wires exiting the back of the fixture. The
fixture power connection wires are inside the housing.
Remove the fixture from the carton and place it on a
Blue
White/Red
Green
Red
Fixture
Gray
Violet
Black
White
Installation Instructions – ClearCurve Wall
Figure 6.
Figure 7.
non-scratching surface. Open the fixture by loosening
the eight flat head phillips screws located on the door
(Figure 7).
2. Separate the door assembly from the top housing by
un-plugging the wire connection and unlatching the two
balled end cables. Store the door assembly in a safe
and dry location.
3. Remove the wedge plate from the back of the top
housing assembly by loosening the two set screws on
the fixture (Figure 1).
4. Attach the wedge plate to the wall surface (Figure 2).
The wedge plate must be mounted with hardware able
to support a fixture weight of up to 50 lbs.
Cooper Lighting Solutions
IB516118EN Installation instructions
2.38"
3.62"
3