Advertisement
PART NUMBER :
WR 534 WORX RACE SPONSONS
SEADOO 05 on all GTX, RXP, RXT
06 on GTI
IMPORTANT:
INSTALLATION
Tools necessary for installation:
Parts Supplied:
1. Remove the OEM sponsons using the Torx screw driver, make sure that you
Clean all of the silicone from the hull surface because the Worx backing rails
Fit up flush to the hull surface.
2. Apply a bead of silicone around edges of the backing rails and around each
mounting hole
3. Fit the WORX side rails to hull using the 10 OEM screws and the QEM flat
washers.
4
Fit the WORX sponson blades using the 10 x 1"/1/4" round head bolts and the 10
large 1 ¼"x ¼" flat washers, use loctite on the bolts.
P.T.O. Continued:
READ ALL INSTRUCTIONS BEFORE PROCEEDING WITH
1 x T30 Torx driver
1 x Tube of silicone
Red Loctite
2 x Worx adjustable Sponsons
2 x Worx Side rails
10 x 1 ¼" x 1/4"Round head bolts
10 x ¾"x ¼" Flat Washers
10 x 1¼" x ¼" Flat Washers
Advertisement
Table of Contents
Summary of Contents for Worx WR 534
- Page 1 2. Apply a bead of silicone around edges of the backing rails and around each mounting hole 3. Fit the WORX side rails to hull using the 10 OEM screws and the QEM flat washers. Fit the WORX sponson blades using the 10 x 1”/1/4” round head bolts and the 10 large 1 ¼”x ¼”...
- Page 2 7 Warning: These sponsons will vastly improve the turning capability of your boat take time to get use to them before you attempt any hard cornering. Thank you for purchasing Worx Racing Components products. We believe that Worx Racing Components products are among the finest watercraft parts available.
Need help?
Do you have a question about the WR 534 and is the answer not in the manual?
Questions and answers