Sears COLOR SWITCH PLUS 7.5FT REGAL FIR M44793 Owner's Manual page 2

7.5FT REGAL FIR
TREE ASSEMBLY INSTRUCTIONS
Congratulations on purchasing your new tree from
on how to quickly and easily set up your new tree.
1. Before you start to assemble your tree, choose an appropriate location near a wall outlet.
2. Assemble the tree stand and place on a level surface.
Fig.A-Tree Stand Assembly
Fig.B-Tree and Light Assembly
Section 2
Section 1
3. Assemble the tree from the bottom to the top. Start with the bottom section and insert into the assembled
stand. Make sure the pole is firmly inserted and secured into the stand. Then connect the tree's light string
adaptor( F) to rotating stand's end cord(C).
(Please note 8-functions control box(E) is wrapped in the lowest layer, if the remote control disappears, you can
control the light string here.)
4. Continue by inserting the upper tree section to the lower section until inserting the tree top.
5. Finally shape the tree by arranging the tips on the branches to give the desired effect. Some tree
styles have "side branches" attached to the main branch stem that require additional shaping as shown
Fig.C. After shaping the complete tree the finished look should be natural and full.
Fig.C
MODEL #:W-2183RT-76KHZ
SEARS.
(See Fig. A)
Section 3
C
Carefully follow the instructions below
（1） Slide 4 legs (B) upwards
into main engine(A)
（2） Three functions of stand
I-Lights on
Stand does not rotate
O-Off
II-Lights on
Stand rotate
*Electrical Rating For The Tree
(For Indoor Use Only)
Input: 120V~60Hz, 0.25A
Output: 29V-0.45A
E: Control Box
Button A: ON/OFF
Button B: COLOR
Button C: MODE
1.STEADY ON
F
2.SLOW SPARKLING
E
3.QUICK SPARKLING
4.SLOW FADE
5.QUICK FADE
6.SLOW GLOW
7.FLASHING
8.COLOR SWITCHING
D