netsys NS-280FX User Manual

netsys NS-280FX User Manual

8-port unmanaged gigabit sfp media converter switch

Advertisement

Quick Links

8 8
x x
S S
F F
P P
S S
l l
o o
t t
s s
w w
8
x
S
F
P
S
l
o
t
s
w
N N
S S
- -
2 2
8 8
0 0
N
S
-
2
8
i i
t t
h h
2 2
G G
i i
g g
a a
u u
n n
m m
i
t
h
2
G
i
g
a
u
n
m
U U
S S
E E
R R
' '
S S
M M
U
S
E
R
'
S
M
F F
X X
0
F
X
a a
n n
a a
g g
e e
d d
E E
t t
h h
e e
a
n
a
g
e
d
E
t
h
e
A A
N N
U U
A A
L L
A
N
U
A
L
r r
n n
e e
t t
s s
w w
i i
t t
c c
h h
r
n
e
t
s
w
i
t
c
h

Advertisement

Table of Contents
loading

Summary of Contents for netsys NS-280FX

  • Page 1 ’ ’ ’...
  • Page 2: Copyright

    In the interest of improving internal design, operational function, and/or reliability, NETSYS reserves the right to make changes to the products described in this document without notice. NETSYS does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.
  • Page 3: Foreword

    There are lots of Multiple ports SFP switches in the market always power source is not enough to driver VDSL2-SFP / G.fast module or encounter overheat issue. Therefore, Netsys company put lots of effort for power source and good heat dissipation as NS-280FX's SFP slots are separated to each other, and build in two internal fans to prevent SFP module overheat issue.
  • Page 4 NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Use ONLY the dedicated power supply for your device. Connect the power cord to the right supply voltage (110V AC used for North America and 230V AC used for Europe).
  • Page 5: Table Of Contents

    NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Table of Contents Copyright ................................2 Foreword ................................3 Safety Warnings ..............................3 Chapter 1. Unpacking Information ........................7 1.1 Check List ....................................7 Chapter 2. Installing the Device ......................... 8 2.1 Hardware Installation .................................
  • Page 6 NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Appendix C: Mounting the Switch on a Rack………………………………………………………………………. 18 Appendix D: Troubleshooting .......................... 19 Appendix E: Compliance and Safety Information ..................22 Warranty ................................25 Chinese SJ/T 11364-2014..........................26...
  • Page 7: Chapter 1. Unpacking Information

    NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Chapter 1. Unpacking In formation 1.1 Check List Carefully unpack the package and check its contents against the check list. Package Contents: 1 x NS-280FX 1 x QR code for user’s Accessory: manual hyperlink.
  • Page 8: Chapter 2. Installing The Device

    2.1 Hardware Installation This chapter describes how to install the device and establish the network connections. The NS-280FX may be installed on any level surface (e.g. a table or shelf, 19 inch rack or wall mounting). However, please take note of the following minimum site requirements before one begin.
  • Page 9: Connecting The Ethernet Of Rj-45 Ports

    NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 2.3 Connecting the Ethernet of RJ-45 Ports NS-280FX has two Ethernet ports which support connection to Ethernet operation. The devices attached to these ports must support auto-negotiation or 10Base-T, 100Base-T or 1000Base-T, and note they don’t support half duplex.
  • Page 10: Application Diagram

    With 8 SFP slots and suitable SFP transceiver, NS-280FX is able to be considered as an IPDSLAM, and would perfectly fit in Fiber / XDSL networking system. NS-280FX also enable user to segment their SFP network, and set up multiple isolated network at your premises, such as your home, office, school, etc.
  • Page 11: Chapter 3. Hardware Description

    Chapter 3. Hardware Description This section describes the important parts of NS-280FX. It features the front panel and rear panel. 3.1 Front Panel: The front panel shown as interface with 8 x SFP Slots, 2 x RJ-45 Connector, Slide switch for Isolation function and LED indicators.
  • Page 12 NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Table 3-1 Description of the front interface Port Name Interface Type Description E1 / E2 RJ-45 connector For connecting to a Backbone or IP gateway networking device. SFP slot For small form-factor pluggable transceiver.
  • Page 13: Led Indicators

    NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 3.2 LED Indicators The NS-280FX has 16 LED indicators. The following Table shows the description. (Table 3-2) Table 3-2 LED Indicators Description and Operation LEDs Color Status Description...
  • Page 14: Appendix A: Cable Requirements

    NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Appendix A: Cable Requirements A.1 Ethernet Cable A CAT 5~7 UTP (unshielded twisted pair) cable is typically used to connect the Ethernet device to the Modem. A: 10/100TX cable often consists of four pairs of wires, two of which are used for transmission.
  • Page 15 NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Figure A-2 Pin Assignments and Wiring for an RJ-45 Straight-Through Cable Figure A-3 Pin Assignments and Wiring for an RJ-45 Crossover Cable...
  • Page 16: Appendix B: Product Specification

    NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Appendix B: Product Specification Key Features and Benefits: Supports 2 x 10/100/1000BASE-T & auto–MDIX for RJ-45 port Supports 8 x 1.25G SFP Slots Cost effective bridge function for FTTdp/FTTC application...
  • Page 17 NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Specification: Item Description Protocol and Standards : IEEE 802.3u / IEEE802.3ab / IEEE802.3z Ethernet: 1000Base-T Cat.5 or above UTP Cable Fiber Optic: 1000Base-X Flexible (Depending on Fiber Cabling requirements:...
  • Page 18: Appendix C: Mounting The Switch On A Rack

    NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Appendix C: Mounting the Switch on a Rack 1. Position a mounting bracket on one side of the rack, lining up the two screw holes on the bracket with the screw holes on the side of the rack as figure below.
  • Page 19: Appendix D: Troubleshooting

    Network interface (ex. a network adapter card on the attached device), network cable, or SFP Cause: transceiver defective. Verify if both of the NS-280FX (all devices) and attached device are powered on. Be sure the Ethernet cable and fiber optics are plugged into both the switch and corresponding device.
  • Page 20 Cause: RJ-45 port link on half duplex mode or LED jitter happen Please make sure opposite side device setting on full duplex mode, since NS-280FX doesn’t Solution: support helf duplex mode. If LED jitter it mean both internal chipset without compatible.
  • Page 21 NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 down by implementing the new changes, one step at a time. Ensure that cable distances and other physical aspects of the installation do not exceed recommendations. System Integrity As a last resort verify the switch integrity with a power-on reset.
  • Page 22: Appendix E: Compliance And Safety Information

    NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 Appendix E: Compliance and Safety Information FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a computing device, pursuant to Part 15 of FCC class A rules.
  • Page 23 NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 proper functioning of your equipment. If they do, you will be notified in advance in order for you to make necessary modifications to maintain uninterrupted service. This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to state tariffs.
  • Page 24 NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 FCC Warning This equipment has been tested to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
  • Page 25: Warranty

    NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 2002 and restricts the use of six hazardous materials found in electrical and electronic products. All applicable products in the EU market since July 1, 2006 must pass RoHS compliance. Directive 2011/65/EU was published in 2011 by the EU, which is known as RoHS-Recast or RoHS 2.
  • Page 26: Chinese Sj/T 11364-2014

    NS-280FX : 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3 The above warranty is in lieu of any other warranty, whether express, implied, or statutory, including but not limited to any warranty of merchantability, fitness for a particular purpose, or any warranty arising out of any proposal, specification, or sample.

Table of Contents