Advertisement
Sensor Hand
Sanitizer
Dispenser
Installation & Operating
Instruction Manual
Thoroughly read this instruction booklet
before operating Sloan dispensers.
Keep this Installation & Operating
Instruction Manual with other product
information for future reference.
Electronic Dispensers
SJS-1450 Sensor Hand Sanitizer Dispenser
Specifications
Width
Height
Depth
Power Supply
Installation
Dispenser Rate
Capacity
Specifications are subject to change
without notice.
Table of Contents
4.75" (121 mm)
14.75" (375 mm)
5.88" (149 mm)
Four (4) AA batteries
Wall Mount
Approx. 1.5 mL/spray
1 L cartridge
Page
2
3-6
7
7
8
8
8
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Sloan SJS-1450
Summary of Contents for Sloan SJS-1450
-
Page 1: Table Of Contents
Thoroughly read this instruction booklet before operating Sloan dispensers. Dispenser Keep this Installation & Operating Instruction Manual with other product information for future reference. Electronic Dispensers SJS-1450 Sensor Hand Sanitizer Dispenser Specifications Width 4.75” (121 mm) Height 14.75” (375 mm) Depth 5.88”... -
Page 2: Dimensions
Dimensions Parts... -
Page 3: Installation And Set-Up
INSTALLATION Tools for installation Using double face tape to Drill bits install the mounting plate Electric drill When the installation area does not allow Phillips screwdriver drilling, use double face tape to mount the Tape measure/ruler dispenser by placing the tape on the back Hammer of the mounting plate after is has been cleaned of dust, dirt, oils and grease with... - Page 4 STEP 3 STEP 5 Attach the main body and the Attach Tray wall cover plate Attach the tray to the wall cover plate as Remove rubber dust plug from sensor shown in the figure on the (right). Push it cable plug hole and discard. Align the in until the tabs of the wall cover plate main body to the cover plate as shown fasten it.
- Page 5 STEP 7 STEP 8 Opening/Closing the Cover Installing/Replacing Batteries To open, push in the tab of the key into The supplied alkaline batteries are the keyhole at the top of the main body. provided only for checking operation and Hold the cover in one hand, it will open to are not intended for general use.
- Page 6 STEP 9 Removing/Changing out Sanitizer Cartridge 1. Open the cover. 2. Take out solution from the individual package. 3. Set solution cartridge into the main body as illustrated below. 4. Remove the cap attached to the pump. 5. Close the cover. STEP 10 Adjusting Spray Open the cover and press the discharging...
-
Page 7: Operation
OPERATION MAINTENANCE This touch-free dispenser is designed to Battery life automatically dispense sanitizer using 1. A blue flashing LED indicates that the alkaline batteries (4 AA batteries). The life of the batteries will end soon. sensor detects a hand placed at the 2. -
Page 8: Troubleshooting
SJS-1450 5700601 The information contained in this document is subject to change without notice. Sloan HEALTHMINDER ™ Products 10500 Seymour Avenue Franklin Park, IL 60131-1259 Phone: 877-652-6726 Fax: 800-447-8329 www.sloanvalve.com ©2009 Sloan Valve Company Printed in the U.S.A. JSD6050.2 01/09...
Need help?
Do you have a question about the SJS-1450 and is the answer not in the manual?
Questions and answers