Page 1
Connect to the Float. For this you will need a mobile device with WiFi. On your mobile device, disable ‘mobile data roaming’ (your 3G/4G/LTE/5G data). Look for available WiFi access points and connect to ‘Float AP #’, where # is the serial number of your Float, which is shown on the white label on the Float Register your Float.
Page 2
Float to ‘Measure’ mode. Your Float will now start communicating with my.brewbrain.nl. You can now screw the lid back onto the Float. Tighten the lid firmly by hand. You can do a leak test by holding the cap under water and checking for bubbles.
Page 3
If you still experience any issues: • Assign a static IP for your Float via DHCP settings. The Float's MAC address can be found by con- necting to the Float's access point (Float in 'setup' mode) and entering the 'Maintenance menu'.