Martha Stewart Living Snow-People Lawn Ornament Quick Start Quide

Assembly Plan:
Snow-People Lawn Ornament
from Martha Stewart Living | www.marthastewart.com

INSTRUCTIONS

Cut flashing to lengths listed below, then
drill holes where indicated. Holes are
listed in order: #1, 2, 3, 4, 5, 6, and 7.
Roll each piece of flashing so holes #1,
3, 5, and 7 align. Place hex huts where
shown and move snowballs down the rod
until they reach the heights indicated on
diagram.
For Head:
1. Cut 53-inch piece of flashing
2. Drill holes at 1, 8, 15, 23½,
32, 42, and 52 inches.
For Middle:
3. Cut 76" piece of flashing
4. Drills holes at 1, 11½, 22,
34¼, 46½, 60¾, and 75 inches.
For Bottom:
5. Cut 106-inch piece of flashing
6. Drill holes at 1, 16, 31,
47¼, 63½, 84¼, and 105 inches.
Move snowballs down threaded rod until
bottom of hat is 5 inches from top of rod,
bottom of head is 11½ inches from top of
rod,
bottom of middle is 21 inches from top of
rod, and bottom of biggest snowball is 34
inches from top of rod.
© 2014 Martha Stewart Living Omnimedia, Inc. All rights reserved. For personal use only, not for commercial use.
indicates hex nut placement
5 inches from top of
rod
11½ inches from top
of rod
20½ inches from top
of rod
34 inches from top
of rod