Blending Tips; Frequently Asked Questions; Food Processor Accessory (Select Models Only) - Oster PRO 1200 User Manual

Blending Tips

Liquids
Put liquids into the jar first, unless the recipe says otherwise. Add more liquid if
ingredients are not blending properly.
Using the Filler Cap
Do not remove the lid while in use. Instead, open the filler cap to add smaller
ingredients.
Ice Crushing
Without Liquid: use Pulse button until you achieve desired results.
With Liquid: Add desired amount of ice cubes and water until ice floats. Blend
on High until you achieve desired results then strain off water.
Working with Hot Foods or Liquids
WARNING:
When you work with HOT FOODS, remove the filler cap to
vent steam. Tilt the lid away from you partially covering the opening. Keep
hands and other exposed skin away from the lid opening to prevent
possible burns.
WARNING:
When you work with HOT LIQUIDS, remove the filler cap and
start at a low speed, and then gradually increase to a faster speed. Do not
add liquid over the 4 cup (1L) level. Always keep hands away from steam.
Ingredient Quantities
Use only the amount of food suggested in the recipes. If you want greater
amounts, prepare in batches. Using larger amounts may overload and strain
the motor. You might also get different results from those described.

Frequently Asked Questions

Why doesn't the blender turn on?
• Make sure the base is plugged in an active power receptacle.
• Verify blinking blue light is active after pushing the power (
How can I prevent liquids from leaking out?
Check to see that the sealing ring is correctly assembled in between
the blade and the jar.
French_BLSTMB Series_16EFM1.indd 10-11
) button.
10

Food Processor Accessory (Select Models Only)

Food Pusher – Use to safely push
ingredients into Slicing/Shredding
Disk.
Cover – The feed tube allows the
addition of ingredients while processing.
Slicing/Shredding Disk – Specially
designed for slicing and shredding.
CAUTION: Blade is sharp, handle
with care.
Blade Shaft – For use with Slicing/
Shredding Disk.
S Blade – Specially designed for
chopping and mincing. Grasp the
plastic Center Hub when handling the
Blade.
CAUTION: Blade is sharp, handle
with care.
Bowl – 5-cup capacity allows for fast
processing of hard-to-chop foods.
Adaptor – Transfers the power
of your Motor Base to the Food
Processor Accessory.
Before Using for the First Time – After unpacking, disassemble unit before using
for the first time.
Wash all parts (except Adaptor) in warm, soapy water.
Rinse and dry immediately. DO NOT IMMERSE ADAPTOR IN ANY LIQUID.
ALL PARTS EXCEPT ADAPTOR ARE TOP RACK DISHWASHER-SAFE.
Food Pusher
Cover
Slicing/Shredding
Disk
Plastic Center Hub
Blade Shaft
S Blade
Bowl
Flexible Seal
Adaptor
Motor Base
11
2/15/16 9:05 AM