Installing Drivers (For Intel ® E810-Cam2) - Supermicro AOC-S100GC-i2C User Manual

3-4 Installing Drivers (for Intel
To install drivers for the AOC-S100GC-i2C add-on card for either Linux and Win-
dows, please follow the instructions below.
Building Driver RPM Package
Please follow the steps below to build a binary RPM package for this driver.
Note: RPM functionality has only been tested in Red Hat distributions.
1. Run the following command, where <x.x.x> is the version number for the
driver tar file.
# rpmbuild -tb ice-<x.x.x>.tar.gz
Note: For the build to work properly, the kernel currently running MUST
match the version and configuration of the installed kernel sources. If you
have just recompiled the kernel, reboot the system before building.
2. After building the RPM, the last few lines of the tool output contain the loca-
tion of the RPM file that was built. Install the RPM with one of the following
commands, where <RPM> is the location of the RPM file:
E810-CAM2)
®
3-3
Chapter 3: Installation