Page 1
Gunite Automatic Slack Adjusters ® Gunite Automatic Slack Adjuster ® Installation Procedures Assembled in the USA Your only single source for industry-leading wheel end solutions. STEEL & ALUMINUM WHEELS | DRUMS | HUBS | ROTORS | SLACK ADJUSTERS...
Page 2
Gunite Automatic Slack Adjusters ® wARNING As with all products, close attention should be given to all instructions incorporated in these instructions, in particular, the notes and warnings which are highlighted. Failure to strictly adhere to these notes and warnings may cause the unit to not perform as designed and result in a weak or “NO BRAKE”...
Page 3
Gunite Automatic Slack Adjusters ® 5. Thread the 1-1/4" collar nut 7. Once the slack is properly aligned, tighten the 1-1/4" collar nut onto the clevis and install to the clevis using 40 to 50 ft. lbs. of torque. the template over the large 8.