Cutting Tool Accessories - Harbor Freight Tools Hydrostar Drain Monster Owner's Manual & Safety Instructions

cutting tool accessories

There are four Cutting Tools included with each Drain Cleaner. Select the appropriate
tool for the cleaning job and attach to Cable. Each is described below.
Spade cutter
Starting tool
For cutting and
scraping.
Boring Bulb
cutter
Starting tool
For removing
loose objects.
NOTICE:
If the cause of the obstruction is unknown, use the Boring Bulb Cutter to explore
the obstruction and, if possible, retrieve a piece to inspect. Once you can see the cause of the
obstruction, select the appropriate tool for the job. Run the smallest available tool through the
blockage to allow the backed up water to flow and carry away the debris as the drain is cleaned.
Once the drain is flowing, more appropriate tools can be used on the rest of the blockage.
Keep in mind that the largest tool used should be no bigger
than the drain's inside diameter, minus an inch.
If properly used, the Drain Cleaners and assorted Cutting Tool Accessories will not damage
a drain that is in good condition and properly designed, constructed, and maintained.
However, if the drain is in poor condition or has not been properly designed, the drain cleaning
work may damage the drain. If possible, visually inspect the drain's quality before operation.
tHiS appLiancE iS intEnDED FOr HOuSEHOLD uSE OnLy
Items 68285 68284 For technical questions, please call 1-888-866-5797.
c-cutter
Finishing tool
For grease
stoppages and
cleaning pipe walls.
arrow cutter
(2 pieces)
Finishing tool
For scraping the
inside edges of pipes.
Page 7