Advertisement
INSTALLATION
•
This product must be installed in accordance with the IET Wiring Regulations
(BS7671) and the Building Regulations. If in any doubt, contact a qualified
electrician.
•
The recommended installation height (measured from air outlet to the floor) 1.2m
for men, 1.1m for women, and 0.9m for children.
•
The electrical connection must be made
using a double pole isolating switch with a
break contact distance of at least 3mm.
•
As shown in (Figure 2), remove two screws from the
cover, follow directions ① & ②, then remove the cover.
Figure 2
•
As shown in (Figure 3), drill 3 holes of 6mm diameter using the template provided.
•
Fix the base on the wall by using the plugs and screws provided (Figure 4).
•
For concealed wire installation: remove the original power cord, feed the prepared
wire into the hand dryer through the base hole, and connect the wire to the wiring
terminal N, L.
•
Following directions ③ & ④ in (Figure 2) put back the cover and replace the
attaching screws.
APPLICATION
•
After finishing the installation, and switching on the power, the hand dryer will switch
on automatically when hands are placed underneath the air outlet.
The hand dryer blows the hot air when hands are 11cm or closer to the air outlet,
•
and it stops working 1 second after removing hands. It will also stop working
automatically after 1 minute consecutive use. To restart the hand dryer, put hands
back underneath and the dryer will switch on again.
•
The sensitivity of the hand dryer is set at the highest value. If it operates for too long
or does not work after installation, please adjust the sensor.
Figure 5
Figure 3
3
Figure 4
Advertisement
