Advertisement
THE RANGE
The stainless steel series ATRIUM insect killer are
the best solution for the destruction and control
of flying insects. The neutralization of insects is
by trapping on glueboards. ATRIUM can be
suspended from the ceiling or wall mounted.
WARNING
ATRIUM MUST ONLY BE USED IN AREAS WHICH ARE
FREE OF DUST AND POSSIBLE EXPLOSIVE VAPOUR
MIXTURE. SHOULD YOU HAVE ANY QUERIES
CONTACT YOUR LOCAL FIRE AUTHORITY FOR
ADVICE BEFORE INS-TALLATION.
ATRIUM IS ONLY SUITABLE FOR INDOOR USE AND
IS NOT SUITABLE FOR USE IN BARNS, STABLES and
SIMILAR LOCATIONS.
INSTALLATION
ATRIUM unit requires certain conditions to ensure
the effective control of flying insects in your
premises:
1– It must be correctly sited
2– It must be the correct model for the area to be
protected
3- It must be in operation for 24 hours a day.
POWER REQUIREMENTS
ATRIUM units are designed to operate from the
following power supply : 220V / 50Hz
Therefore, please ensure that your unit is
compatible with the electricity supply in your
premises.
DANGER: this product is subjected to a high
voltage
IMPORTANT
This fly killer is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience of knowledge, unless they have
been given by a person responsible for their
safety, monitoring or instruction concerning
use of the appliance (A2/EN 68335-1). It should
supervise children to ensure they don't play
with the fly killer.
POSITIONING
ATRIUM unit should ideally be fixed at least
two meters above the ground, preferably in the
darkest place within the area to be protected,
away from windows and skylights, thus avoiding
ATRIUM
– INSTRUCTION SHEET
any competition with natural daylight or
sunlight.
In large open areas where two or more units are
required, siting needs careful consideration to
ensure maximum protection. Each unit within a
certain area should be centrally positioned.
The wall mounting is carried out by means of
suitable equipments (bolts, screws, etc...) to the
weight of the unit. The suspension makes edding
using chains (not includes).
SERVICING
BEFORE ANY FORM OF SERVICING, ENSURE THAT
THE UNIT IS DISCONNECTED FROM THE MAINS
SUPPLY.
To maintain the units efficiency, replace the UV
fluorescent bulbs every 12 months. For glue
versions, glueboards must be replaced every two
months.
IF
INSTRUCTIONS, PLEASE CONTACT YOUR SUPPLIER.
GUARANTEE
ATRIUM is guaranteed for 5 years (excluding
replacement bulbs and glueboards). If a fault
occurs, contact your supplier, who will replace
your unit providing the product has been
operated under normal conditions.
ATRIUM 30i
ATRIUM 300i
ATRIUM 400i
ATRIUM 800i
ATRIUM 30 Gi
ATRIUM 300 Gi
ATRIUM 400 Gi
ATRIUM 800 Gi
ANY
DOUBTS
ARISE
Models
Power supply
220V – 50 Hz
220V – 50 Hz
220V – 50 Hz
220V – 50 Hz
220 – 50 Hz
220V – 50 Hz
220 – 50 Hz
220V – 50 Hz
REGARDING
THESE
UV light
Protection area
2 x 15 W
50 m²
2 x 15 W
80 m²
2 x 20 W
120 m²
2 x 40 W
240 m²
2 x 15 W
50 m²
2 x 15 W
80 m²
2 x 18 W
120 m²
2 x 40 W
240 m²
Advertisement
