Ryobi PSP02 Operator's Manual page 7

WARNING:
Use safety equipment. Protect your eyes, skin, and lungs
while mixing, filling, spraying, and cleaning. Failure to do
so may result in serious personal injury and damage to
property.
CAUTION:
Wear shoes with a leather sole while using this sprayer.
Do not wear shoes with a rubber sole, or similar insulat-
ing footwear.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
APPLICATIONS
You may use this product for the purposes listed below:
 For use with industrial and consumer grade disinfecting
chemicals
 Applying disinfectant solutions in professional, medical,
and custodial settings and a variety of other industrial
applications
INSERTING AND REMOVING THE NOZZLE
See Figure 1, page 13.
 Turn electrostatic function off and remove the battery
from the unit.
 Rotate the dial so the nozzle you are going to insert or
remove is in the 6 o'clock position.
To insert:
 Insert the nozzle (with o-ring) into the front of the nozzle
dial.
 Rotate the nozzle clockwise until the o-ring is sealed
against the face of the mode selector. Do not over-tighten.
To remove:
 Rotate the nozzle counterclockwise and remove the nozzle
(with o-ring) from the mode selector.
OPERATION
USING THE MODE SELECTOR
See Figure 2, page 13.
The sprayer has three spray modes and a prime mode.
Rotate the mode selector to choose the appropriate mode.
NOTE: When one of the spray modes is selected, the word
"SPRAY" will appear in the indicator window. When the
prime mode is selected, "PRIME" will appear in the indica-
tor window.
 PRIME - Select this mode and squeeze the trigger to
draw liquid from the tank and through the lines to create
a consistent spray.
 SPRAY (50 Microns) - Select this mode to create a spray
made up of small droplets that absorb quickly.
 SPRAY (75 Microns) - Select this mode to create a spray
made up of medium sized droplets.
 SPRAY (100 Microns) - Select this mode to create a
spray made up of large droplets that absorb slowly.
NOTE: Select the correct nozzle for optimal performance.
Some products become less effective if absorbed too quickly
or too slowly. Refer to the manufacturer's instructions for the
product you are spraying.
NOTE: If nozzles become clogged, see instructions in Main-
tenance section to clear blockage.
FILLING THE TANK
See Figures 3 - 5, pages 13.
Before filling the tank, always remove the battery pack.
Turn electrostatic function off before removing the bat-
tery from the unit. Wipe up any spills before inserting the
battery pack. Following this rule will reduce the risk of
electric shock and corrosive liquids entering the battery
pack, which can cause battery pack failure including short
circuit resulting in smoke, fire, and/or serious personal
injury.
Always follow the chemical manufacturer's instructions
printed on their product labeling for use, cleaning, and
storage. Do not combine chemicals. Clean thoroughly
after each use, following the instructions in the
Maintenance section of this manual. Chemicals should
be stored out of the reach of children. Failure to do so
may result in serious personal injury.
7 – English
WARNING:
WARNING: