Advertisement
Quick Links
Advertisement
Summary of Contents for DAC RA711-GSM
- Page 1 DAC LIMITED USER GUIDE RA711-GSM...
-
Page 2: Table Of Contents
Contents Introduction Mounting Options Electrical Connection Operation SMS Configuration and Status Reporting Commands Quick Start Guide General Care and Maintenance... -
Page 3: Introduction
This user guide is designed to assist with the operation of the RA711 GSM (3G/4G), provide simple installation instructions and explain the various programming and reporting parameters available. If you require more detailed technical information please contact your supplier or DAC Limited direct. GSM Antenna GSM (3G/4G) -
Page 4: Mounting Options
Mounting Options Wall Mounting Top of Pole Mounting Inset [Flush] mounting using In Wall Box Top of pole mounting bracket Part No. RA711-IW or Surface mounting [Part No. 552642] available using rear enclosure Part No. RA711-OW. from DAC Limited. -
Page 5: Electrical Connection
Electrical Connection - VERY IMPORTANT The HOOK LED indicator should be OFF when the telephone is ON HOOK and should be ON when the telephone is OFF HOOK. During incoming ringing the LED will flash slowly and if a FAST FLASH is observed this indicates that the telephone is NOT registered on the network. When configured the INPUT / OUTPUT Terminals monitor a CHANGE OF STATE ONLY and are volt free contacts. -
Page 6: Operation
Typical command parameters would include, but is not limited to: Telephone Location - this can be up to 30 characters long identifying the telephone location e.g. DAC Limited BB7 9ED. Reporting Number - this configures the desired number(s) [up to 3] where the telephone reports its’... -
Page 7: Commands
Commands USERTEXT message The telephone compiles and sends an SMS text message [USERTEXT] to a command origina- tor, to confirm changes of configuration after an incoming command has been processed, or to a maximum of three (3) SMS destinations as asynchronous responses to changes in telephone status. - Page 8 Each telephone can be programmed with its own unique location reference, this can be configured remotely is limited to 30 characters and must not contain the symbols ‘,’ [comma]or ‘.’ [full stop]. The following command sets the location to DAC Limited BB9 7DR: CLO1234.DAC Limited BB7 9ED...
- Page 9 Configure PIN change command [PIN] The product is PIN protected for security purposes [default 1234] if a new PIN is required the following command will change the PIN from 1234 to 5678: PIN1234.5678.5678 The new PIN must be provided twice for confirmation and separated with a ‘.’ [full stop]. The originator [the person who sent the SMS command] and the USER LIST will receive the following message indicating that a parameter has been modified: Location: {location of telephone} this can be configured via SMS...
- Page 10 Configure Parameters Command (CFG) This describes the parameters that can be configured/monitored and should only be used following consultation with your supplier or with DAC Limited direct.
-
Page 11: Quick Start Guide
Quick Start Guide 1. Unpack telephone, you have been supplied with: Ÿ RA711-GSM Telephone Ÿ Mains power pack 12V DC 2A (optional) Ÿ GSM Antenna (optional) 2. Insert valid SIM card into telephone SIM holder 3. Connect antenna ensuring instructions are followed on page 3 [Electrical connection] 4. -
Page 12: General Care And Maintenance
The RA711 Telephone does not require any regular maintenance. To clean wipe with a damp cloth. Do not use any abrasive cleaners on the telephone as this may cause the telephone to become discoloured. DISTRIBUTED BY: DAC Limited, Union Mill, Watt Street, Sabden, Lancashire. BB7 9ED Tel. 01282 447000 Fax.
Need help?
Do you have a question about the RA711-GSM and is the answer not in the manual?
Questions and answers