ELECRAFT KXBC2 Quick Manual

KXBC2 Smart Battery Charger/KXBT2 Li-Ion Battery Pack
Use only the KXBC2 charger to charge your KXBT2 battery pack.
Observe the precautions on the reverse side of this sheet.

Charge the Elecraft KXBT2 battery pack before installing in the KX2. The battery cannot be
charged while installed the KX2.

Typical charging times are 2 hours for a fully depleted battery pack; 1 hour for recharging in
normal conditions.

Install the charged KXBT2 battery pack in your KX2 as described in your KX2 Owner's manual.

The KXBT2 battery pack delivers less than 12 V when fully charged. You may need to reduce
your KX2 power output accordingly (See Transmit Settings in your KX2 Owner's Manual).
FEATURES

Constant-Current Charge at 2000 mA, stabilized output with low ripple.

Over-voltage protection

Short-circuit protection

Polarity error protection

Over-power protection
LIMITED WARRANTY:
until ninety (90) days thereafter (the "Warranty Period"). Notwithstanding anything to the contrary herein, no warranty for
any Product shall be enforceable in the event that the Product has been subjected to environmental or stress testing by Buyer
or any third party without written approval of Seller prior to such testing, or if the alleged defect or nonconformity is a result
of abuse, misuse, neglect, tampering, unauthorized or improper use or installation, disassembly, repair, alteration, or accident
by Buyer. During the Warranty Period, Buyer shall promptly notify Seller in writing of any alleged nonconformity or defect
covered by this limited warranty.
Elecraft
Revision B, September 16, 2016
Copyright © 2016, Elecraft, Inc. All Rights Reserved
IMPORTANT!
For the Battery Pack and Charger, the warranty shall be effective from the date of shipment
Elecraft • www.elecraft.com
E740288
• 831-763-4211