EINHELL AGILLO Original Operating Instructions page 31

12. Never fully discharge the battery pack (re-
commended depth of discharge max. 80%)
A complete discharge of the battery pack will
lead to premature ageing of the battery cells.
13.Never charge the batteries unsupervised.
Protection from environmental infl uences
1. Wear suitable work clothes. Wear safety gog-
gles.
2. Protect your cordless tool and the battery
charger from moisture and rain. Moisture
and rain can cause dangerous cell damage.
3. Do not use the cordless tool or the battery
charger near vapors and infl ammable liquids.
4. Use the battery charger and cordless tools
only in dry conditions and an ambient tempe-
rature of 10-40°C.
5. Do not keep the battery charger in places
where the temperature is liable to reach over
40°C. In particular, do not leave the battery
charger in a car that is parked in the sunshine.
6. Protect batteries from overheating. Over-
loads, over-charging and exposure to direct
sunlight will result in overheating and cell
damage. Never charge or work with batteries
which have been overheated – replace them
immediately if possible.
7. Storage of batteries, battery chargers
and cordless tools. Store the charger and
your cordless tool only in dry places with an
ambient temperature of 10-40°C. Store your
lithium-ion battery pack in a cool, dry place at
a temperature of 10-20°C. Protect them from
humidity and direct sunlight. Only place fully
charged batteries in storage (charged at least
40%).
8. Prevent the lithium-ion battery pack from free-
zing. Battery packs which were stored below
0°C for more than 60 minutes must be dispo-
sed of.
9. When handling batteries beware of electro-
static charge: Electrostatic discharges cause
damage of the electronic protection system
and the battery cells. Avoid electrostatic char-
ging and never touch the battery poles.
Anl_SA_Agillo_SPK8.indb 31 Anl_SA_Agillo_SPK8.indb 31
GB
Rechargeable batteries and cordless electric
machines and tools contain materials that are po-
tentially harmful to the environment. Never place
any cordless electric machines or tools in your
household refuse.
Additional safety instructions
•
Before you begin your work, examine the ma-
terial you want to cut. Remove any foreign bo-
dies. Continue to watch out for foreign bodies
while you are working. If you come across any
foreign bodies while cutting, turn off the ma-
chine and remove the items in question.
•
Work only when visibility is adequate.
•
Always hold the equipment firmly in both
hands. Your fingers and thumbs should be
wrapped around the handles.
•
Make sure that the handles are clean and dry.
•
When carrying out mowing work on a slope
always stand at a lower level than the cutting
tool. Never cut or trim on a smooth, slippery
hill or slope.
•
Make sure you stand squarely at all times
while working. Be careful when walking back-
wards. Tripping hazard!
•
Never leave the equipment unsupervised in
the work area. If you stop work for a while,
leave the equipment in a safe place.
•
If you stop your work in order to go to another
area to work, you must make sure that the
equipment is switched off while you are going
there.
•
Never use the equipment while it is raining or
in damp or wet surroundings.
•
Protect your equipment against moisture and
rain.
•
Before you switch on the equipment, check
that the cutting unit will not touch any stones
or other objects.
•
Always wear suitable working clothes to pre-
vent injuries to the head, hands and feet. For
this purpose wear a helmet, safety goggles
(or visor), high boots (or strong shoes and
long trousers made of tough fabric) and work
- 31 -
11.06.2019 10:34:22 11.06.2019 10:34:22