JOBE Addict Tower 2.0 Installation Manual

Warning: Before drilling into your boat, please check that
you have clear access to the area beneath and that no
objects, wires, or other hazards are present.
Tip: Do not measure from windscreen, cleats or vents.
These reference points are not always square and in the
same position as the opposite side of the boat. It's the best
to use the front of the boat as the reference point, the top
edge of the deck mould, or similar measurement points
whenever possible. Always triple-measure and check
before drilling.
Tighten the deck mounts firmly so that the mounts will
rotate under pressure while turning the mount with the
leg attached (note the mounts will be very hard to rotate
by hands)
Step 6
Attach the tower onto the deck mounts. To make your job easier, you can remove the short front curve legs from the tower assembly at this stage, and move the front horizontal
bars in or out to fit the rear deck mounts and connect it with M12 washer and bolts. Then lift the tower and re-assemble the curve legs on, rotate it to fit the front deck mounts, and
connect to the mounts with M12 bolts and washer.
NOTE: When you have a narrow boat you probably need to shorten the overhead bar to make the tower fit to your boat.
Step 7
Drill through the predrilled holes in the center section from each side with size 10 drill bit and install bolts and cap nuts. One person will still be stabilizing the tower through this
step. Tighten all hardware for completion of tower installation.
Step 8
Double check If the tower is in the correct position you can fasten all the bolts and screws
How to fold the tower
I. Disconnect tower front legs from the deck mounts.
II. Loosen the connection between the front legs and rear legs.
III. Push the tower top it will fold from front to down position.
Care and maintenance
I. Be sure to check and tighten all fasteners and connections prior to every use.
II. Be cautious when driving under obstacles, low hanging structures or trees with your tower mounted.
III. Use soap and water or general cleaners to clean your tower. Avoid abrasive materials that might scratch the bimini's finish.
IV. Always rinse tower after contact with salt (brackish) water.
JOBE Addict Tower Warranty
Jobe Sports International warrants this product (not including other 3rd party accessories) against manufacturers defects. Anodizing and powder coated surfaces as well as all
hardware corrosion are specifically excluded as their care and use cannot be controlled by Jobe Sports International. Any modifications or improper use shall void this warranty.
Jobe Sports International is not responsible for personal injury or damage to the boat caused by the use of this tower. JOBE's obligation under this warranty shall not include any
transportation charges or costs of installation or any liability for direct, indirect or consequential damages resulting from delay or improper installation. No dealer, retailer or
manufacturer is the agent of Jobe Sports International and may not assume for Jobe Sports International any liability in connection with this warranty. This warranty is in lieu of all.
Distributed by:
Jobe Sports International
Heerewaardensestraat 30, 6624 KK Heerewaarden
The Netherlands WWW.JOBESPORTS.COM
tower manual.indd 1-2
REAR MOUNT ASSEMBLY FRONT MOUNT ASSEMBLY
ADDICT SWEPT FORWARD
WAKEBOARD TOWER
INSTALLATION GUIDE
03-10-16 13:29