Dimavery EPVP-50 Manual

EFFECT PEDAL EPVP-50, VOLUME
This device is an effect pedal for attenuating musical instruments. This product was designed for
indoor use only.
INTRODUCTION
Unpack your device. Before you initially start-up, please make sure that there is no damage
caused by transportation. Should there be any, consult your dealer and do not use the device.
SAFETY INSTRUCTIONS
This device has left our premises in absolutely perfect condition. In order to maintain this condition
and to ensure a safe operation, it is absolutely necessary for the user to follow the safety
instructions and warning notes written in this user manual.
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will
not accept liability for any resulting defects or problems.
Keep away from heaters and other heating sources!
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
There are no serviceable parts inside the device. Maintenance and service operations are only to
be carried out by authorized dealers.
Maintenance and service operations are only to be carried out by authorized dealers. Damage,
caused by manual modifications on the device are not subject to warranty. If the device is used for
other purposes than originally intended or if it is not correctly connected, the product may suffer
damages and the guarantee becomes void.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth.
Never use alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to
be carried out by authorized dealers.
Should you need any spare parts, please use genuine parts. Should you have further questions,
please contact your dealer.
© Copyright
Nachdruck verboten!
Reproduction prohibited!
EPVP-50 Effect Pedal, Volume
Footswitch
MIN Volume
Input
A & B
Output A & B
OPERATION
Install the device on a plane surface.
The device has no ON/OFF switch. As soon as you insert a jack into an IN socket, it beginns
running.
All connections are made with standard 6.3 mm jack plugs.
Signals form Input 1/2 are led to Output 1/2.
You can set the volume level by either turning the volume level control or by pressing the pedal
until you reach the desired level.
Turning the MIN Volume Control fully clockwise will increase the volume at the minimum
setting. This allows you to set the volume range.
TECHNICAL SPECIFICATIONS
Dimensions (LxWxH): 240 x 85 x 100 mm
Weight: 485 g
Please note: Every information is subject to change without prior notice. 05.03.2007 ©
EPVP-50
Input Sockets
Plug in your instruments, effect unit, etc.
Output Sockets
Plug in your amplifier here
Footswitch
Turns the effect ON/OFF.
MIN Volume Control
Adjusts the volume range.
26370490_V_1_1.DOC
www.dimavery.com