Telefunken HappyCare HCCV2 Instruction Manual page 17

ENGLISH
Tank release button
Grasp the water tank handle with the hand and press the tank release button with one finger, then you
can take out of the water tank for filling water.
Front & Rear support
You can put the iron on the front & rear support during operation and you can also secure the iron into
front & rear support for storage after finishing ironing.
Working indicator
After plug up, the working indicator will be illuminated. While the soleplate is heating up, the working
indicator will be flashed. When achieve the target temperature, working indicator will be changed
flashing to illuminating, which indicates you can iron with steam.
Temperature dial
Turn the dial to set ironing temperature to meet the garment changed.
Steam trigger
Press the steam trigger with a little force, the steam will be sprayed from the soleplate continuously.
When loosen the steam trigger, the appliance can only be used for dry ironing without steam.
Lack of water indicator
If less water in the tank, the indicator will be illuminated, following with two "D" sounds of buzzer. It
prompts you to add water into the tank.
Reset button
If less water in the tank, the lack of water indicator will be illuminated, at that time, you need to refill
the water tank. After refill the water tank with water, hold and press the reset button for about 2 seconds
to make the lack of water indicator be extinguished and then you can release steam for ironing.
Cord clamp
When not in use, the power cord and supply cord shall be stored. Pull out the cord clamp first, after
winding the cords around the cord winding groove, push the cord clamp back.
4