Advertisement
Table of Contents
Board Layout and Pin Functions
+5V
GND
Power Button
3B,4
Switch (SW1)
1
1
2
ON
1
2 3 4 5 6 7 8
6
Programming
Header
1
4
3
2
1
DC Output
3A
+12V/+24V
+12V/+24V
GND
GND
Note:
1. The headers of Programming, RS232 and SMBus are used for internal test only. Please do not connect
them to avoid functions fail.
2. Please adjust switch (SW1) only when the power output is off.
3. There are two cables to connect X103-DC36 power baord and main board.
A. One power cable connects the DC output of X103-DC36 and the DC input of the main board.
B. One signal cable connects the power button headers of X103-DC36 and the main board.
4. The power button header pin 1 of X103-DC36 must connect to power button header pin "+" of the main
board.
X103-DC36
DC to DC Converter
2
SMBus
1
9
1
5
1
6
2
10
2
RS232
Header
1
Standby Power LED
Ignition
DC
GND
Input
VIN
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for DFI X103-DC36
- Page 1 A. One power cable connects the DC output of X103-DC36 and the DC input of the main board. B. One signal cable connects the power button headers of X103-DC36 and the main board. 4. The power button header pin 1 of X103-DC36 must connect to power button header pin "+" of the main board.
- Page 2 X103-DC36 DC to DC Converter SW1 - System on/off Control Table Output Voltage Switch (SW1) Select Pin 1 +12V +24V Power On Delay Switch (SW1) Time Select Pin 2 Pin 4 Pin 5 3 Sec 10 Sec 30 Sec 1 Min...
Need help?
Do you have a question about the X103-DC36 and is the answer not in the manual?
Questions and answers