Do you have a question about the REACH-IN STORAGE Series and is the answer not in the manual?
Questions and answers
Summary of Contents for Leer REACH-IN STORAGE Series
Page 1
Leer, Inc. 206 Leer Street, P.O. Box 206 New Lisbon, WI 53950 1-800-766-5337 www.leerinc.com STORAGE FREEZER INSTALLATION, OPERATION, AND SERVICE MANUAL WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer (For more information go to www.p65warnings.ca.gov)
Storage and Transportation: is available. Contact the Merchandiser Sales Department at Leer, The freezer should be stored and transported in an Inc. for additional information. upright position. It is not recommended to tilt the freezer.
Information regarding the electrical voltage and frequency being supplied to the merchandiser can be found on the merchandiser’s serial data plate typically located at the upper left corner of the merchandiser’s interior. Information regarding the maximum fuse/circuit breaker size required for the specific model is available from the condensing unit data plate.
This alarm will continue to display until the control). The controls have been programmed the cabinet temperature rises above the minimum by Leer to operate the freezer within the design level. parameters of the refrigeration system. The set- Note: Should a “P1” or “P2” alarm occur, check the point (cut-out) has programmed parameters for -12°...
• The simplest and preferred method would Leer does not assume responsibility for any damage to people or things deriving from violation, involve the use of a vacuum cleaner to suck the improper use, or in any case not in compliance debris out of the coil from the outside surface.
housing. The condensate evaporator’s heat element merchandiser. On outdoor cabinet models, the melt water will exit the drain tube directly to the ground. is energized continuously so the surface of the On indoor cabinet models, the consumer needs to housing should always be hot to the touch. If testing install the condensate evaporator heater assembly the heat element with a meter, the element can be unplugged from its’...
Page 8
lubrication. If the door moves part way from the two-finger location but stops short of the cabinet, the compression of the gasket along the hinge side of the door should be checked. If there is too much compression, the door will bind when closed and should have its hinge-mount location checked and possibly adjusted.
Page 9
4) Using the Adjustment Pin, turn the Adjustment Collar until the Pin contacts the Hinge. Then insert the Stop Pin in hole of Adjustment Collar (Fig. 3). CAUTION: The Stop Pin must fully seat on Adjustment Collar. Failure to do so may cause the Stop Pin to become dislodged. Inserting the Adjustment Pin more than halfway thru the Adjustment Collar can cause partial push out of the Stop Pin.
__________________________________________________________________________________________ __________________________________________________________________________________________ Warranty: REFRIGERATED REACH-IN STORAGE FREEZERS: Seller warrants the freezer under normal use and service, for one (1) year for the component parts (to be shipped by seller), and ninety (90) days for repair labor from the date of original shipment. The freezer compressor motor is warranted for five (5) years from the date of original shipment.
Page 14
MODEL NO. ______________________ SERIAL NO. ______________________...
Need help?
Do you have a question about the REACH-IN STORAGE Series and is the answer not in the manual?
Questions and answers