Dragon Strand Breeder Series Assembly Instructions

Getting Set-up

Tools Needed:

Phillips Head Screwdriver
Scissors (to unwrap parts)

Step 1: Attach the Vine Holders

These vine holders attach to the top panel and will provide a convenient anchor
to loop artificial vines. They can also be used to hang any internal decorations or
feeding bowls that fit into your design.
Find the two pre-drilled holes on the top panel and attach the vine holders using
the screws included in the vine holder bag.

Step 2: Construct the Cage Core

The cage core is the top, back, and bottom panels attached. Use the long screws to
attach these panels together. Attach them laying horizontally on a table as shown.
The core will not be independently stable yet.
A) To attach the Top Panel, line up the screw holes on the top of the Back Panel and on the back of the Top Panel
frame. The Top Panel attaches to the PVC side of the back panel with the vine holders on the cage inside.
B) The Bottom Panel is attached in the same manner as the Top Panel. Attach with the groove side of the Bottom
Panel facing down.
Medium Wide
These assembly instructions are good for any of the Breeder Series Cages. Note that the Large Breeder
Cage has one additional front panel which will get specific mention.
Unpacking: Carefully unpack the cage pieces and familiarize yourself with the pieces. Each piece has a
label on it which identifies where it goes.
When unwrapping the pieces you will find two small bags. One holds screws and one holds small
plastic clips. The screw bag contains many large screws and four small screws. The small screws are for
attaching the door hinges. The plastic clips are your vine holders.
Assembly Instruc
Breeder Series Cage
Medium Tall
tions:
Large

Goal of Step 2