Adjusting Airflow - Polaris Totally Wicked User Manual

USING YOUR POLARIS
REMOVING THE CARTRIDGE
To remove the cartridge from the Polaris, push
the mouthpiece away from the power button
to tilt the cartridge and release the magnetic
retention, then push the cartridge upwards
and out of its compartment.
PRIMING THE ATOMIZER HEAD
It is important to prime an atomizer head
before use to prevent it from prematurely
burning. To do this, remove the cartridge
from the battery and remove the atomizer
head by pulling, drip a few drops of e-liquid
on the visible cotton inlets on the sides of
the atomizer head and push back into the
cartridge. Push the cartridge back into the
battery.
ATOMIZER HEAD LIFESPAN
Atomizer heads do not last forever and
need to be replaced periodically. Lifespan is
generally from a few days to several weeks,
depending on power used, vaping style,
flavour and type of e-liquid. A slight burnt
taste, general loss of vapour production,
or a reduction in flavour intensity can all be
indicators that the atomizer head requires
replacement.
14
FILLING THE CARTRIDGE
Open the filling flap on the cartridge, insert
your e-liquid bottle nozzle into the inlet and
fill. Leave a minimum air gap of around 2mm.
Close the filling flap.
Note: Please wait 5 minutes after filling the
cartridge before vaping to allow the atomizer
head to fully saturate with e-liquid.
POWER ON/OFF
To turn the Polaris on or off, press the power
button 5 times in quick succession.
VAPING
Press the power button and inhale on the
Polaris mouthpiece, the device will begin to
produce vapour.

ADJUSTING AIRFLOW

Remove the cartridge and locate the airflow
adjuster below the filler flap. Slide the adjuster
up to decrease airflow or down to increase.
ADJUSTING THE WATTAGE
The power on the Totally Wicked Polaris is
adjustable, to do this press the up and down
buttons below the display to adjust up and
down respectively.
15