Page 1
- link to a Windows PC for KMG Capture. Use to mix in speech and other controls. Green “P” LED = good connection. PROG - Titan buttons change slot display. 1= Mouse , 2= Xbox 360, 3= AUTO/Xbox One, 4=PS4, 5=Switch. 6-9 Custom. A / B - connect XAC and/or gamepads.
Page 2
D-PAD = cursor keys = enter key tapped = ALT+F4, or held = ESCAPE SHIFT TO SLOT 2 = tap SHIFT x 6 SLOT 2 = Xbox 360 controller – use for PC and Raspberry Pi. = START. = BACK.
Page 3
↑ NORTH 2. GCM Joystick Modes N1 = Menu buttons N2 = XBOX - TITAN SLOT 2 or 3 N3 = Shoulder buttons N4 = Menu buttons (RetroPie) ↑ N5 = → ↓ ← SHIFT + move stick , or 1-6 times.
Page 4
2. Start the GTuner IV utility (free from consoletuner.com). Select a gaming slot (e.g. slot 2 for PC, RetroPie, or slot 3 for Xbox One). Press F4 and with Keyboard ticked, click on “ENTER CAPTURE MODE”. 3. Click on the Device Monitor tab and experiment with the keys below.
Page 5
Voice Attack speech commands Start Voice Attack: Use the “GCM Speech (Xbox One)” profile available from OneSwitch. Say “LISTEN TO ME” or “STOP LISTENING”. Start GTuner IV. Click “Device Monitor”. Press F4. Tick “Keyboard”. Start KMG Capture mode. All Xbox commands are available.
XAC: To use your XAC wirelessly with the Titan, follow the guidance above, then pair your Titan and XAC: Hold the Titan button until the display rolls, turn your XAC on (hold the Xbox button), then press ))). A steady white XAC Xbox light and steady Titan number display indicates a good connection.
Authentication error. Check your controller is powered up. Check you are in the right SLOT for your games machine (try 3 if in doubt). Disconnect XAC then hold Xbox button until light goes out. Reconnect. Power down Xbox One controller or power off PS4 controller (press tiny button on back with paperclip).