Advertisement
7
7 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (7A) to Faucet Inlets (7B). (Supply lines and
fi ttings are not included).
8
8 POP-UP ROD CONNECTION
Insert Lift Rod (8A) into hole at the back of Faucet (8B). Gently, slide Lift Rod
(8A) down the hole in Faucet (8B).
POP-UP DRAIN BODY INSTALLATION STEPS
9
9E
9A
9G
9A
9K
9L
9G
9C
9 POP-UP PREPARATION
Remove Flange (9A) and unscrew Nut (9C) from the Pop-Up Drain Body
(9B). Retain the Packing Ring (9D) inside the Ball Rod Opening (9E). Take
off the Spring Clip (9F) from the Ball Rod (9G). Place the Nut (9C) over
the Ball Rod (9G). Remove Locknut (9H), Friction Washer (9J), Rubber
Washer (9K), and Stopper (
9K), and Stopper (
9L) from Flange (9A).
9K
7B
7A
8A
8B
9C
9D
9F
9B
9J
9H
9B
9E
9E). Take
ENGLISH
10
10A
10A
10C
10D
10E
10F
10 POP-UP INSTALLATION
Apply a small bead of putty underneath the Flange (10A) and place a ring of
putty around Drain Opening (10B) of sink. Use PTFE plumber's tape to all
threaded fi ttings according to manufacturer's instructions. Insert Flange (10A)
into Drain Opening (10B). From underneath, insert Rubber Washer (10C) and
Friction Washer (10D) over the bottom of Flange (10A). Thread Locknut (10E)
until Rubber Washer (10C) seats securely inside Drain Opening (10B). Thread
Drain Body (10F) to bottom of Flange (
10F
10F) to bottom of Flange (
Body so that the Ball Rod Opening (10G) faces the rear. Wrench tighten Locknut
(10E) and wipe excess putty.
10E) and wipe excess putty.
10E
11
11F
11 BALLROD ADJUSTMENT
Drop the Stopper (11A) into the Drain Body (11B) from the top with the Off-Set
(11C) facing rear. From below, insert the Ball Rod (11D) into the Ball Rod Opening
(11E) through the Stopper Hole (
11E) through the Stopper Hole (
11E
3
10B
10G
10A). Hand tighten and adjust the Drain
11A
11C
11D
11E
11B
11F) and secure with the Nut (
11F) and secure with the Nut (
11F
10E
10E)
11D
11G
11G).
Advertisement
