TECHWOOD TFV-109 Instruction Manual page 9

● Unroll the power cord completely.
● Check that the tension in force in the country where you are corresponds to
that indicated on the apparatus.
● Connect the apparatus in a correct socket-outlet, (and connected to the
ground if the unit is Class I), to avoid any danger.
● Disconnect the power source cable before any operation of cleaning of
maintenance and accessories assembly.
● Stand the appliance on a table or flat & stable surface.
● The item must not be left unattended when it is connected to main supply.
● The item is not to be used, if it has been dropped or if there are visible signs
of damage or if it is leaking.
● Never modify the appliance in anyway.
● To avoid a circuit overload, do not operate another high wattage appliance
on the same circuit.
● When the iron is returned to its iron rest, make sure that the surface that
supports the iron rest is stable.
● The iron must be used and rested on a stable surface.
● Fill the tank (up to the maximum level) before connecting.
● Select the desired temperature (see above table), the iron gets hot.
● When the desired temperature is reached, the iron is ready for use.
● After use, set the thermostat and unplug the iron.
To fill the tank :
Press the button under the iron handle to unfold.
The handle will lift automatically.
Detach the tank by pulling the handle backwards by
the button of the tank.
Open the tank and fill with clean water.
Replace the tank and secure it using the button on the
tank.
(Do not exceed the maximum level).
USE
Filling with water
9