Dungs DLU 02 Operating And Installation Instructions

Always read the operat-
ing and installation in-
structions before start-up!
Work on automatic burner
control systems may only
be carried out by trained spe-
cialist personnel!
Never carry out work when
a voltage is present!
This is also important when
exchanging or installing low-
voltage components such as
servo motors, displays or com-
munications components.
Check the functioning of
the device if fuses are
defective.
Only trained specialist
personnel may set the
operating parameters.
The communication con-
nection may only be used
in conjunction with the ap-
proved components.
The in-phase connection
and the protective con-
ductor connection shall be car-
ried out in accordance with the
wiring diagram and checked
before start-up.
Tampering with the elec-
tronics or inappropriate
storage renders the device
warranty null and void.
The automatic burner
control system is speci-
fied with the entries made here
and no features are guaran-
teed.
If these instructions are
not observed, damage
to persons or property may
occur.
1 ... 16
Operating and installa-
tion instructions
Power Converter
DLU 02
Description
Microprocessor-controlled power con-
verter for adapting controllers or DDC
systems with power or current interfaces
(0-10 V, 4-20 mA) to eBUS-compatible
automatic burner control systems of
the MPA series.
The device converts analogue power
control signals from an external control-
ler or DDC system into standard eBUS
messages and converts eBUS infor-
mation sent by the automatic burner
control systems into analogue power
or current signals.
Accessories
AM02 display
eBUS connecting cable
(4-wire, 400 mm)
Order data
Type DLU 02
Order No.
230 878 DLU 02
231 582 AM 02 Display