Dahua Technology DH-PFR4K-E50 User Manual page 47

Parameter
Mode
MAC Address
IP Version
IP Address
Subnet Mask
Default
Gateway
Preferred DNS
Alternate DNS
Enable
ARP/Ping to set
IP address
service.
Click Save.
A demonstration of configuring IP address with ARP/Ping
Keep the device that needs to be configured and the PC within the same LAN, and then
get an IP address available.
Get the physical address of the radar from its label.
Open command editor on the PC and enter the following command. See Step 3.
Parameter
Windows syntax
UNIX/Linux/Mac
syntax
Win7 syntax
Description
DHCP: The system acquires IP address automatically. You cannot set
the IP address, subnet mask and default gateway.
Static: You need to configure IP address, subnet mask and default
gateway manually.
Display the MAC address of radar.
Select IP version from IPV4 and IPV6 and both versions can be accessed.
Enter the IP address, subnet mask, and default gateway as needed when
selecting Static mode.
IPV6 has no subnet mask.

The default gateway must be in the same network segment with the

IP address.
IP address of the preferred DNS.
IP address of the Alternate DNS.
Select the check box, get the device MAC address, and then you can
modify and configure the device IP address with ARP/ping command.
It is enabled by default. During restarting, you will have no more than 2
minutes to configure the device IP address by a ping packet with defined
length, the server will be turned off in 2 minutes, or it will be turned off
immediately after the IP address is successfully configured. If the service
is not enabled, the IP address cannot be configured with ping packet.
Table 4-9 Command list
Description
Arp -s <IP Address> <MAC>
Ping -l 480 -t < IP Address >
Example:
Arp -s 192.168.0.125 11-40-8c-18-10-11
Ping -l 480 -t 192.168.0.125
Arp -s <IP Address> <MAC>
Ping -s 480 < IP Address >
Example:
Arp -s 192.168.0.125 11-40-8c-18-10-11
Ping -s 480 192.168.0.125
netsh i i show in
netsh -c "i i" add neighbors ldx <IP Address> <MAC>
41
User's Manual