Advertisement
Table of Contents
Assembly Instructions for ProRak Series Workstations
Part List
1. Legsx4
2. Span Braces 2 long (back span), 2 short (sides)
3. Wing nutx8
4. Complimentary 10-32 rack screwsx8
Instructions:
1. Start by removing the outer packaging. Begin and complete the assembly with the
unit resting in the base of the packaging.
2. Simply screw the numbered legs onto the matching numbered mounting plate
attached to the underside of the workstation.
3. Attach the span braces to the pre-positioned brackets on the legs using the wing
nuts.
4. Lift your workstation onto its legs and remove the remainder of the packaging. You
are ready to load your gear.
1507 S. Olive St. South Bend, In. 46619
www.rabaudio.com
Advertisement
Table of Contents
Summary of Contents for RAB ProRak Series
- Page 1 Assembly Instructions for ProRak Series Workstations Part List 1. Legsx4 2. Span Braces 2 long (back span), 2 short (sides) 3. Wing nutx8 4. Complimentary 10-32 rack screwsx8 Instructions: 1. Start by removing the outer packaging. Begin and complete the assembly with the unit resting in the base of the packaging.
- Page 2 Instructions for keyboard shelf adjustment ProRak 61, MK61, 88, MK88 You will need a Phillips screwdriver/screw gun bit 1. Remove male catches (2) located on the underside of the keyboard tray. (4 screws total) 2. Remove the keyboard tray by fully extending the tray in the outward position and releasing the catch mechanism (plastic tab located in the slide) 3.
Need help?
Do you have a question about the ProRak Series and is the answer not in the manual?
Questions and answers