Page 1
AbbVie Cross Body Pack For use with CADD-Legacy ® 1400 pump This guide pertains only to the use of the AbbVie Cross Body Pack. For questions or problems, refer to these Instructions for Use or call support toll free at 1-844-386-4968.
Page 2
The Cross Body Pack is designed to carry a CADD-Legacy 1400 pump. This Cross Body Pack is intended for single-patient use only. The Cross Body Pack should be worn over the shoulder and positioned at or near the waist using the Belt for support (see Figure i).
Page 3
Precautions: CAUTION: When putting on the Cross Body Pack, ensure the pump is resting on a flat surface, and will not fall (see Figure ii). If the pump is not completely secure, it may fall and injure you or damage the pump.
Page 4
CAUTION: Make sure that the pump is stable on a flat surface, and will not fall while you put on the Cross Body Pack. a. Hold the Cross Body Pack so that the Pull Tab faces out and the zipper is on top (see Figure A).
Page 5
Fasten the clip. Listen for a snap sound. c. Check that the clip is securely fastened (see Figure C). Figure C 3) Adjust the Cross Body Pack: a. Move the plastic slider until the Shoulder Strap is at the desired length (see Figure D).
Page 6
4) Insert the pump into the Pump Pocket: a. Place the pump into the Pump Pocket so that the screen is on the bottom and facing out (see Figure E). Figure E b. Using the Pull Tab, confirm that both the display and the keypad are visible through the Clear Plastic Window.
Page 7
1) Remove the pump from the Pump Pocket: CAUTION: Make sure that the pump is stable on a flat surface, and will not fall while you take off the Cross Body Pack. a. Pull the zipper to open the Pump Pocket.
Need help?
Do you have a question about the Cross Body Pack and is the answer not in the manual?
Questions and answers