Technical Specifications - Optical Systems Design OSD136 Operator's Manual

1.4 TECHNICAL SPECIFICATIONS

TABLE 2 below provides the Technical Specifications for the OSD136.
SPECIFICATION
Data Rate
Optical Transmit Power
Receiver Sensitivity
Optical Link Budget
Receiver Saturation
Optical Transmitter Wavelength
Optical Connector
Signal Loss Indicator
Electrical Connector
Power Connector
Power
Dimensions (mm):
Small Module
Wall Mount Module
Operating temperature
Relative humidity
Page 6 of 16
OPTICAL SYSTEMS DESIGN
TABLE 2: TECHNICAL SPECIFICATIONS
PERFORMANCE
DC to 20kbps asynchronous or synchronous
-20 to -14dBm into 62.5/125 multimode fiber
-20 to -13dBm into singlemode fiber (OSD136L variants only)
< -43dBm
< -42dBm for WA or WB single fiber variants
>23dB @ 850nm for standard OSD136 (>6km of multimode fiber)
>23dB @ 1310nm for OSD136L (>60km of singlemode fiber)
>22dB for WA or WB single fiber variants
> -10dBm
850nm for OSD136 and OSD136C.WA
1310nm for OSD136L, OSD136LC.WA and OSD136C.WB
1550nm for the OSD136LC.WB
ST standard
LED is green with good signal and red with too low an optical
signal
25 pin male D-subminature
1.3mm socket on side of case2-way terminal block on module
+8V to +13V
DC
via pin 9 of the D connector
OR
+4.75V to +5.25V
DC
15H x 44W x 80D (excluding optical connectors)
25H x 104W x 144D
-20 to +75°C
0 to 95% non-condensing
OSD136 OPERATOR MANUAL
@ 150mA supplied by external power supply or
DC
supplied via pin 12 of the D connector
DC
10213607
DOC ID: 10100110