Advertisement
Thank you for purchasing these Cara touch table lamps. Please read the
instructions carefully before use to ensure safe and satisfactory operations of this
product.
Please keep this instruction for future reference.
Warnings!
The supply cable runs through the inside of this product. Take care not to place
undue stress on the cable whilst unpacking to prevent the possibility of a poor
connection.
If you are in any doubt consult a person competent to give advice on the
assembly of electrical equipment.
If the external flexible cable of the lamp is damaged it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified person in
order to avoid a hazard.
To prevent electrocution switch off at the mains supply before assembling or
maintaining this fitting. Ensure the plug is not connected to any power supply
and read instructions before assembly.
Always be sure to use the correct type and wattage of bulbs as indicated on the
fitting. Never exceed the wattage stated.
When changing the bulb, always switch off at the mains and allow the old bulb
to cool down before handling. Dispose of used bulbs carefully.
Caution! The bulb and surrounding parts can become hot during use.
For indoor use only.
Care instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as
these will damage the finish.
Replace bulbs from John Lewis or established brand of the same type and
compatibility.
Parts list
Assembly
Never install your appliance on a wet, freshly painted surface. Ensure to off at the
mains supply before assembling or maintaining this fitting.
Step 1
Unpack the product and remove all packaging. Be
careful not to scratch the surface of the product whilst
removing the wrapping.
Remove the shade ring already attached to the lamp
holder section. Carefully place the shade glass followed
by the spacer (widest end first) over the lamp holder.
Secure the assembly in place by refitting the shade ring
removed earlier. The shade ring tool is supplied to make
refitting the shade ring easier. Simply place the shade ring
inside the plastic shade tool and attach to the lamp
holder section. Take care not to overtighten as this may
cause damage to the fitting. Ensure all components are
straight and aligned during this assembly process.
Step 2
Fit the bulb, type and wattage as indicated on the
fitting (bulb not supplied). The wattage indicated must
not be exceeded.
Table lamp is now ready for use.
Step 2
IL3982
Advertisement
