Advertisement

Quick Links

Operation Manual
Pressure Washer
62571
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.

Advertisement

Table of Contents
loading

Summary of Contents for WilTec 62571

  • Page 1 Operation Manual Pressure Washer 62571 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
  • Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
  • Page 3: Safety Instructions

    Warning! This device has been designed to be used with a cleaning agent provided or recom-  mended by the manufacturer of the device. The use of other cleaning agents or chemicals may impair the safety of the device or even damage the device. © by WilTec Wildanger Technik GmbH Item 62571 Page 3 http://www.WilTec.de http://www.aoyue.eu...
  • Page 4: Power Supply

    Water flowing through a backflow preventer is not considered drinkable. Warning! Always connect the backflow preventer to the water supply and not directly to the pressure washer. © by WilTec Wildanger Technik GmbH Item 62571 Page 4 http://www.WilTec.de http://www.aoyue.eu...
  • Page 5: Technical Specifications

    Water hose connector Power cord Short pressure hose Power plug Pressure hose Water supply hose Hose reel Water tap Power switch Wheels Integrated tank for cleaning agents © by WilTec Wildanger Technik GmbH Item 62571 Page 5 http://www.WilTec.de http://www.aoyue.eu 2020-1 http://www.teichtip.de...
  • Page 6: First Application

    First connect the pressure hose to the sprayer and then to the device frame. The pressure hose can be removed again by pressing the safety catch (A) located on the sprayer and the button (B) located on the inlet coupling of the frame. © by WilTec Wildanger Technik GmbH Item 62571 Page 6 http://www.WilTec.de...
  • Page 7 Note: Always check if the filter has been placed within the water inlet of the device and make sure it is not clogged. Connect the water hose to the water supply via coupling (max. pressure: 10 bar, max. temperature: 60°C). © by WilTec Wildanger Technik GmbH Item 62571 Page 7 http://www.WilTec.de...
  • Page 8 The pressure of the water released by the nozzle can be adjusted. Warning: Never try to adjust the pressure while the device is operating in order to prevent severe injuries from your hand being hit by the high-pressure water jet. © by WilTec Wildanger Technik GmbH Item 62571 Page 8 http://www.WilTec.de...
  • Page 9 Setup © by WilTec Wildanger Technik GmbH Item 62571 Page 9 http://www.WilTec.de http://www.aoyue.eu 2020-1 http://www.teichtip.de...
  • Page 10: Maintenance

    The filter always has to be installed when the device is being used in order to protect the pump valves from sand particles and other pollutants. © by WilTec Wildanger Technik GmbH Item 62571 Page 10 http://www.WilTec.de http://www.aoyue.eu...
  • Page 11: Troubleshooting

    Dirty or clogged water filter Clean the water filter • • but no water is re- Blocked nozzle Clean the nozzle with a needle • • leased © by WilTec Wildanger Technik GmbH Item 62571 Page 11 http://www.WilTec.de http://www.aoyue.eu 2020-1 http://www.teichtip.de...
  • Page 12: Eg-Konformitätserklärung

    It has been tested with the following harmonised standards: Il a été testé à partir des norms harmonisées suivantes: EN 60335-1 :2012+A11, EN 60335-2-79 :2012, EN 62233 :2008 Bevollmächtigter für die Zusammenstellung der technischen Unterlagen: Bernd Wildanger, Geschäftsführer WilTec Wildanger Technik GmbH Königsbenden 12 52249 Eschweiler Deutschland Eschweiler, 22.Mai 2017, Gültig bis 21.
  • Page 13: Disposal Regulations

    All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.

Table of Contents