Table of Contents
Advertisement
Typical vocoding setup
If you're connecting an instrument directly to the Metavox, hook it
up this way:
1. Connect a 1/4" phone cord to the [RIGHT INPUT] of the
Metavox from the instrument you want to have vocoded.
Or, you can just use the Metavox's own waveforms as the synthesis input
source.
2. Connect another 1/4" phone cord from the microphone
preamplifier or mixer's direct output to the [LEFT INPUT]
(as shown below).
3. Connect two 1/4" phone cords from the [LEFT] and
[RIGHT OUTPUTS] of the Metavox to two mixer inputs.
4. If you're connecting directly to a stereo mixer, pan the two
channels hard left and hard right to get the maximum effect.
5. To vocode the instrument, set [SYNTHESIS INPUT] to
RIGHT IN = SYNTH. Otherwise, use either the microphone
or the instrument to control the internal oscillator.
I ns t r um e nt ( s y n t h , gui t a r )
o ut pu t
Fro m DI RECT O UT ( m ic ) to [LEFT I NPUT]
O utpu ts of Metav ox to m ixe r in p uts
Connections
INPUT TRIM affects
only the left input
O nc e yo u 'v e s et y ou r
m ic ro ph o ne p re am p g ain,
c ra nk u p the [I NPUT TRIM]
c on tr ol on th e ba ck of th e
Metav ox un til the S I GNAL
LED o n its to p pa ne l fla s he s
r ed while yo u talk, th en ba ck
it off a b it.
Mos t gu ita rs an d ba s se s h av e
r elativ e ly lo w ou tp u t le v els.
For the qu ie tes t effec t, tu rn
u p th e v olum e o n th e g uitar to
full. I f th a t' s no t e no u gh ,
d on 't c h an ge th e INPUT
TRI M of th e Metav ox .
I ns te ad , p lu g the g u itar in to a
m ix er c h an ne l o r oth er
p re am p fir st.
Mic in
2
19
Advertisement
Table of Contents
