Table of Contents
Advertisement
Reset Mod
Press this button to reset the phase of the phaser modulation
source as follows:
•
In TRIANGLE mode, press [RESET MOD] to start the wave
from the beginning of its phase.
The "starting point" of the phase shift is determined by the setting of the
[CENTER] control
•
In PATTERN mode press this button to generate a new 16-
step pattern.
Bypass
This button sends the signal directly from the input to the output
without any effect. Press [BYPASS] to check the sound of the
source without any effect from the Faze. When the red BYPASS
LED is lit, phasing is turned off. The Bypass function can also by
activated by the foot switch.
Since the Faze is a digital effect, signal always passes through the
digital A/D–D/A conversion process, so that digital signal will
flow through to other effects in a ModLink chain even when
[BYPASS] is on. So, unlike old analog effects, this is not a
"hardwire" bypass switch—the Faze must be powered on to pass
signal through, even in bypass mode. Similarly, the [TRIM]
control is always active, since it's an analog control regulating the
level feeding the analog-to-digital converters.
Using the Foot Switch
If you need to bypass the effect but your hands aren't free, simply
connect any momentary footswitch (such as those used for
keyboard sustain pedals, either NC normally closed or NO
normally open) to the [FOOT SWITCH] jack on the rear panel.
The footswitch will turn the BYPASS LED on and off.
Using the Faze
3
33
Advertisement
Table of Contents
