Getting Started; Select Your Clip; Attach Your Clip; Install Your Remote - sideclick Universal Remote Attachment Manual

Getting Started

Select Your Clip

Select Adapter Clip based on your Amazon
Fire TV Remote
Amazon Remote Style
Voice Remote
Non-Voice Remote

Attach Your Clip

1 -
Line up tabs on Sideclick remote with
keyholes in clip.
2 -
Press clip against Sideclick remote and
slide clip up until it locks in place.

Install Your Remote

Sideclick

Program Your Sideclick

1 - On Sideclick, hold down the
Position your Sideclick remote and the device remote you are learning from on a table, head
2 -
to head, approximately 1 inch apart.
Press and release the Sideclick button you wish to program. The LED will start blinking.
3 -
4 -
Press and release the button you want it to learn from on your device remote.
-The LED will blink 3 times indicating a successful learn, then will return to solid indicating
you are ready to program other buttons.
-If the LED does not return to solid, a problem in programming has occurred. Exit
programming mode via step 6 and try again.
5 - While LED is on solid, repeat steps 3 & 4 for each button you would like to program.
To exit programming mode, press the
6 -
You can also wait approximately 10 seconds and it will exit programming mode
automatically.
Your Sideclick is now ready to use.
7 -
Clip ID
FB
FA
CLIP ID
Amazon Remote
+ buttons simultaneously until the LED lights solid.
+
1
2
VOICE
REMOTE
simultaneously and the LED will turn off.

Removing Your Clip

Gently pull out on locking tab with index
1 -
finger.
2 -
While pulling out on the locking tab,
slide clip down and then away from
remote.
NON-VOICE
REMOTE
2
1