Advertisement
DEVICE SETUP GUIDE
MOUNTING ADAPTER for GoPro
Requires Go Pro
®
camera with waterproof case (not included).
1. Attach ball adapter to the mounting base as show below.
2. Place the camera case onto the adapter so that the two
mounting brackets on the case fit between the (3) mounting
brackets on the adapter as shown (A). Make sure the holes
on both sets of brackets are aligned.
3. Insert the threaded end of the clamping arm into the
bracket holes (B), and thread into the threaded nut
at the opposite end and tighten until snug (C).
Loosen the arm to adjust the angle of the camera.
1 / 4 " THREADED MOUNTING ADAPTER
for devices with a 1/4" threaded mount
1. Attach the ball adapter to the mounting base as shown on the
following page.
2. Screw the 1/4" threaded mounting adapter directly into the 1/4"
mounting hole on device.
PSM31001
Camera/GoPro
®
Mount Base
STEP 1
Choose a mounting location (D).
S T E P 2
Mount base to the appropriate sized clamp ring for the vehicle (E*).
Note: Do not exceed 200 inch-pounds
S T E P 3
Position the base into location by clicking clamp rings into the base.
Then use a 3/16" hex key to fasten the screw & nut (F) included with
the ring clamp*. Continue until
clamp is tight and does not move.
Note: Do not exceed 200
inch-pounds
S T E P 4
Tighten/Loosen the ball and hinge
joint
using the mounted turn knob (G) on
the
mount base.
Note: Use the knob to
loosen, tighten or switch-out the
1/4" -20 screw mount {I)
or the GoPro
®
mount (H).
®
Clamp Removal:
In-order to remove the tube clamp from location, the clamp must
first be tightened to allow base removal. Once tightened, loosen
the clamp and carefully squeeze clamp to remove from the
location.
Note: Use protective film to help avoid damage to the paint. 'Various
ring clamp sizes available (sold separately w/ hardware
Advertisement
