CoolBot Pro Manual

Not Applicable to 2G Model (CoolBot with cables on top and side)
CoolBot Pro
From the CoolBot Pro Controller
1. On the CoolBot​ ​ , press the left arrow button until ​ t he Program light​ ​ is solidly lit. You will see the
firmware version on the display (7.8, 7.9, etc.).
2. Press the Checkmark button​ ​ ​ f ive times slowly,​ ​ until you see "P1" on the display.
3. Press the Left Arrow​ ​ a few times to get to the reset option you want:
○ P1​ ​ : resets all settings (Same as "​ F r​ ​ " )
■ Full factory reset of ​ C oolBot and Jumper​ ​ IF the ​ J umper is connected.
■ Full factory reset of the ​ C oolBot only​ ​ , if the ​ J umper is disconnected.
○ ES​ ​ : escapes from this menu and returns to normal operation
○ CJ​ ​ : clears the Jumper's (Wi-Fi radio) ​ s ettings only. The Jumper HAS to be connected to the CoolBot
Pro.
○ CE: Wi-Fi Mode disabled​ ​ : ​ Y ​ ​ = Not using Wi-Fi, ​ N ​ ​ = Using Wi-Fi (See ​
○ CS​ ​ : clears the CoolBot's settings to defaults but ​ k eeps the Wi-Fi settings​ ​ the same.
○ Fr​ ​ : resets all settings (Same as "​ P 1​ ​ " )
■ Full factory reset of CoolBot and Jumper IF the ​ J umper is connected.
■ Full factory reset of the CoolBot (ONLY), if ​ J umper is disconnected.
4. Press ​ C heckmark ​ ​ t o select that reset option.
5. You will see a blinking ​ " n"​ ​ for "no". ​ P ress one of the arrow keys​ ​ to change it to ​ " y"​ ​ for "yes."
6. Press Checkmark.​ ​ The CoolBot will reset the selected settings.
7. If you chose ​ P 1, CJ, ​ ​ o r​ Fr with the Jumper connected to the CoolBot Pro​ ​ , the CoolBot will switch to its
Wi-Fi Configuration mode. You should ​ s ee the code "E0"​ ​ on the display. This means it's ready to
reconfigure Wi-Fi.
8. The CoolBot set temp has been reset to factory setting of 42F, change it to your desired room temp.

CoolBot Factory Reset

(continue on page 2)
​
© 2018-12A Store It Cold, LLC
​
N OTE​ below)