Advertisement
INSTALLATION INSTRUCTIONS
INSTALLATION -
Orlight does not recommend the cutting of holes prior to receipt of product in hand.
Please see reverse for full instructions.
Allow +5mm for Cable Clearance
DB13 R999
93mm
DB8 R999
73mm
DB6 R999
53mm
LAMP MAINTENANCE
blade tool to lever down one side, then evenly pull the holder downwards to remove it from the fitting .
The lamp and holder will pull through as one, take care not to damage any wires. Change with any
compatible orlight dimmable lamps listed below.
FLAT TOOL ONE SIDE
IP65 DOWNLIGHT
SHOWERSQUARE
LUMENSTAR 3
81mm
36mm
6mm
37mm
84mm
- The lamp holder can be easily removed from the face of the fitting. Use a flat
PULL THROUGH
WWW.ORLIGHT.COM | 01923 851 890
CIRCULAR
Allow +20mm for Cable Clearance
CUT OUT : 72MM
37mm
84mm
36mm
37mm
6mm
84mm
CHANGE LIGHT SOURCE
LUMENPLUS 3
81mm
Advertisement
Table of Contents
Related Manuals for Orlight ShowerSquare
Summary of Contents for Orlight ShowerSquare
- Page 1 INSTALLATION INSTRUCTIONS IP65 DOWNLIGHT SHOWERSQUARE INSTALLATION - Orlight does not recommend the cutting of holes prior to receipt of product in hand. Please see reverse for full instructions. CIRCULAR Allow +5mm for Cable Clearance Allow +20mm for Cable Clearance CUT OUT : 72MM...
- Page 2 For full Terms and Conditions, please visit our website at: https://www.orlight.com/en/terms-and-conditions.html Hole cut out: Orlight does not recommend cutting of holes prior to receipt of product in hand. Please refer to reverse or Orlight’s technical support/website for recommended hole cut out. Wiring: Disconnect the mains supply before installation.
Need help?
Do you have a question about the ShowerSquare and is the answer not in the manual?
Questions and answers