F5 ARX 2000 Replacement Script page 5

This section describes the ARX-2000 LEDs. It is provided for reference only. NSE can obtain more
information from the ARX2K Hardware Installation guide. (F5 internal only):
http://techpubs.acopianet.com/danwood2/pubs6_0_0/docs/HW_InstallA2K/HWInstall.pdf
LED definitions:
LED State
Blinking
Flashing
Flickering
The lower left of the front panel contains the LEDs shown on the picture above.
The table below contains details on the status and alarm LED functions.
Callout Feature
A Alarm LED
B Status LED
C Power Supply
LED (status of
both power
supplies
aggregated into
one LED)
Definition
LED turns on and off at a steady rate.
LED is off most of the time. Occasionally, the LED
illuminates.
LED turns on and off at an erratic (not constant)
rate.
Function
Indicates various alarm states.
When blinking, the LEDs blink ON for a half second
and OFF for a half second.
see next table
The status LED displays green, yellow, or red with
intermittent blinking patterns, depending on the
state.
When blinking, the LEDs blink ON for a half second
and OFF for a half second.
The LED displays:
• Green, indicating power is on.
If you receive an SNMP trap indicating a power
supply failure, go to the back of the switch and
examine the power supplies to determine which
has failed. The LED on the failed power supply
will be amber. For details on the states indicated
by the power supply LED, see Power Supply
LED, on page 4-7.
For details on replacing a failed power supply,
Copyright © 2010, F5 Networks, Inc. All rights reserved.
For details on the LED colors and blinking patterns,
- 4 –