At Trouble
The watch temporarily
gains or loses time.
The reception results
are successful, but
Misalignment
the precise time is
not displayed.
of the time and
hand positions
T h e s e c o n d h a n d
position is not correctly
aligned in the reception
results display or the
reception level display.
7
The watch displays an incorrect time
hour unit, even though it displays the
precise time of minutes and seconds
162
At trouble
The reception results are successful
Misalignment
and the precise time is displayed, but
of the date
the date is not correctly displayed.
The crown or buttons
cannot be operated.
Operation
You get lost in
the middle of the
operation.
Blur on the dial glass
Others
persists.
7
※ F or the solution of troubles other than the above, consult the retailer from whom the watch was purchased.
164
Possible causes
The watch has been left in an extremely high or
low temperature place for a long time.
The watch fails to receive a radio signal correctly as
a result of external infl uence (incorrect reception).
The hand positions were misaligned as a result of external infl uence.
The hands are out of the preliminary position as a result of external infl uence.
→ Preliminary Position P.156
The second hand is out of the preliminary
position as a result of external infl uence.
→ Preliminary Position P.156
The setting of the time zone or time diff erence
is wrong.
Possible cause
The date is out of the preliminary position.
This happens when the date is out of the preliminary position as a result
of infl uence of various external sources or after the built-in IC is reset.
The stored electric power is running short.
Hands and date are moving right after a setting
is carried out by the crown or button operation.
−−−−−−−−−−−−−−−−−−−−−−−−
Small amount of water has got inside the watch
due to deterioration of the gasket, etc.
Solutions
1. When the watch returns to a normal temperature, it will display the precise time as before.
2. If the watch still gains or loses the time, conduct manual reception if necessary.
3. I f the watch cannot resume normal movement even after conducting the above mentioned
procedures, consult the retailer from whom the watch was purchased.
1. Place the watch where it is able to receive a radio signal more easily.
2. Conduct manual reception if necessary.
1. N o crown or button operation is needed, since the automatic hand position
adjustment function will be activated to align the hand positions. Automatic
Hand Position Alignment Function activates once an hour for the minute and
second hands and at 12:00 both for the AM and PM for the hour hand.
2. I f the watch still gains or loses time, refer to In Case of an Abnormal Movement
to perform procedures.
3. I f the watch cannot resume normal movement even after conducting the above
mentioned procedures, consult the retailer from whom the watch was purchased.
Check the time zone or time diff erence currently set. Change the setting of the
time zone or time diff erence so that it is set within the same region as the place
where the watch is used.
Solution
Set the date to the preliminary position 1 (the 1st).
Sufficiently charge the watch until it starts moving at one-second
intervals.
Wait without doing anything.
After the date stops, the crown and buttons can be operated.
1. If the crown is pulled out, push it back in.
2. T he watch will resume its normal one-second interval movements within 5 minutes.
3. S tart the setting procedure from the beginning.
Contact the retailer from whom the watch was purchased.
Reference pages
−
P.149
−
P.111
P.148
P.156
P.151
P.166
−
7
P.122
P.124
163
Reference pages
P.168
P.116
−
−
−
7
165