Toro V Service Manual page 35

751.I,0490.2
HINGE PIN
3. Hold the governor collar on the carburetor
and lift the air vane/throttle shaft out of the
carburetor. Lift the collar and spring up,
detaching the spring from the speed control
lever.
4. Turn the carburetor over and remove the
four bowl retaining screws, the bowl gasket
and the bowl. Discard the bowl gasket.
5 . .
Remove the fuel filter from the fuel nozzle.
6.
Remove the float hinge pin, the inlet valve
needle assembly (with its clip) and the float.
Discard the needle and clip.
of the cork.
7. Inspect the float for cracks or deterioration
Service Section 5-9