quadient Parcel Pending Lite Hardware Installation Manual

Parcel Pending Lite
Hardware Installation Guide
Accessories per column Accessories per
module
x 4 x 8
x 4
Feet
Feet fixing
Caps
x8
[B]
screws
d
x 2
x 2
Clips
Feet connectors Type C LR14 alkaline
Recommended batteries:

Stacking and numbering rules

Locker 11
Locker 1
Locker 21
Locker 8
Locker 7
Locker 10 Locker 20 Locker 24
Assemble the modules in the order defined in your installation
plan (lockers are numbered from top to bottom and from left to
right).
A2

Tighten the feet fixing screws with the service door key

(f).
A8
A7
If there is going to be a column adjoining Repeat steps
this one, use the feet connectors (e). other position 1 modules.
Accessories per People
locker facility
x 2
Locker labels Cleaning
batteries
wipes
Duracell Pro
Maximum modules per column = 4
A3
Screw the foot in fully.
B
Stacking of
position 2/3/4
modules
Position 4
Position 3
Position 2
Position 1
A1 to A7 for the
Tools supplied
Service door key
x 2
g
Spanner
Position 4 Position 4
Position 3 Position 3
Position 2
Position 2
Position 1
Position 1
A4
for the three remaining feet. Turn the module over and put it in its final
Repeat steps A1 to A3
B1
B2
Transport wedges
Bottom
Back
Remove the transport wedges from underneath Turn the module over then place it on top of the
the module. module below.
Module types
Type L+XS Type 2M
A
A1
Preparing position 1
modules
Position 4
Position 3
Position 2
Module
Position 1
type [L+XS]
prohibited

Place the foot fixing screws

A5
Bottom
Top
x 2
location.
B3
Bottom Top
x 2

Push the module towards the back until it stops.

Type 3S Type 4XS
Bottom
(b) in the holes of the foot (a).
A6
g
Ensure that the module is stable. If not, adjust the foot that is not
in contact with the floor using the spanner (g).
Back
x 2