Hose Holder - Makita DGP180 Instruction Manual

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Removing or installing barrel
To remove the barrel, screw it as illustrated.
1
► 1. Barrel
To install the barrel, insert it into the tool then screw in
reverse.
1
► 1. Barrel
Rod handle
Pull the rod handle when installing grease in the barrel.
1
► 1. Rod handle 2. Rod
2
9 ENGLISH
To lock the rod handle fully pulled, pull the rod handle
until the groove on the rod can be seen, and then hook
the groove onto the slot. To unlock the rod handle,
unhook the groove so the rod moves forward.
► 1. Groove 2. Slot
CAUTION:
Make sure the rod handle is locked
firmly. Otherwise it may be unlocked accidentally and
cause a pinching.
NOTE: To pull the rod handle while the barrel
installed in the tool, loosen the valve of the air drain to
let air comes into the barrel.

Hose holder

The hose holder can be attached to either side of the
tool with the screw.
1
2
► 1. Hose holder 2. Screw
2
1
1
2