Summary of Contents for HobbyKing SCRATCH/DENT Salangane
- Page 1 ELECTRIC / SLOPE CONVERTABLE WING AREA: 34dm FUSELAGE: 1185mm WING SPAN: 2020mm AIRFOIL: MH32 FLYING WEIGHT: 1600g~1800g C.G.:70~80m/m FROM LEADING EDGE...
- Page 2 1. WING PANELS 16. WING SERVO CONNECTOR THROUGH 2. NOSE CONE (2 PCS.) HOLE GUIDE 3. FUSELAGE 17. INNER NOSE ASSEMBLE FIXTURE 4.CARBON TAIL BOOM 18. MAIN WING JOINER 5. INNER NOSE CONE 19. ELEVATOR/RUDDER PUSH RODS 6. V-TAIL 20. SUB WING JOINER 7.
- Page 3 A.FUSELAGE ASSEMBLY-ELECTRIC VERSION 1. Dia. 45mm and 40mm 2 motor mounts are included in this kit for your choice. Use the proper one for the motor you chosed. 2. Cut one nose cone with bore 3. Sand off about 1mm at both side of the mount as slightly smaller than the motor shown in the picture to avoid interfere to the bore mount you chose.
- Page 4 5. Glue #13 (25 x 50mm plywood) ESC mount to the top inside of the nose cone with epoxy glue. 6. Connect motor wiring to the ESC, mount the motor to the motor mount with screws , mount ESC to the ESC mount with double side tape or Velcro tape. 7.
- Page 5 8. Glue jig together with super glue. Use jig to assemble inner nose cone to fuselage, glue them together with epoxy glue. 9. Put nose cone to the fuselage and adjust to correct position, drill a 4mm hole through to the inner nose cone at the distance of 14mm from the edge of nose cone. 10.
- Page 6 11. Sand down the sub wing joiners to fit the holes on the fuselage nicely and glue it to the fuselage with super glue. Both ends of sub wing joiner should be with same length. 12. Glue V-TAIL wing joiners to the tail boom, face the beveled side together. B.
- Page 7 14. Install horn to ELEVATOR/RUDDER fix with super glue then add epoxy glue to fill up the empty space. Note: Do not over use epoxy glue to avoid interference of the movement of the ELEVATOR/RUDDER. C. ELEVATOR/RUDDER PUSH ROD INSTALLATION 15.
- Page 8 16. Drill (do not drill through hole)a 3mm hole at 8mm distance from the leading edge of the bottom side of the aileron at proper location aligns to the servo horn. Glue aileron horn to the hole with epoxy glue. 17.Drill a 3mm hole at flap trailing edge and glue the flap horn into the hole with...
- Page 9 19. Connect aileron and flap servos with extension cords and p I through the servo leads from servo mounting holes to the wing root servo leads out hole. 20. Prepare aileron push rod with a Z bend at 38mm length then mount the servo as shown in the photo.
- Page 10 22. Prepare 2 pcs. of 6 pin servo connector with 50CM wire length pull it through the wing servo connector lead out hole on the fuselage for wing se o connection.
- Page 11 D. FUSELAGE AND TIL BOOM ASSEMBLY 23. Assemble V-Tail to tail boom and install Tail-Boom to the fuselage. Make sure the V-tail is parallel to the main wing before glue them together with super glue.
Need help?
Do you have a question about the SCRATCH/DENT Salangane and is the answer not in the manual?
Questions and answers